跳转到主内容

配件

没有特定配件。

  1. Before removing the battery from the laptop, make sure the power is off.
    • Before removing the battery from the laptop, make sure the power is off.

    • Push both battery locking clips outward at the same time.

  2. Slide the battery out of the laptop.
    • Slide the battery out of the laptop.

  3. Remove the four 4-mm screws on the bottom of the laptop using a #0 screw driver.
    • Remove the four 4-mm screws on the bottom of the laptop using a #0 screw driver.

  4. Carefully turn the laptop over and open the screen all the way. Locate the slot to remove the keyboard in the lower left hand corner.
    • Carefully turn the laptop over and open the screen all the way.

    • Locate the slot to remove the keyboard in the lower left hand corner.

    • Using a spudger as a lever, insert it into the slot and gently pry up.

  5. PC 笔记本电池

    所有顶级PC品牌的电池均以我们的质量保证为后盾。

    现在开始购物

    PC 笔记本电池

    所有顶级PC品牌的电池均以我们的质量保证为后盾。

    现在开始购物
  6. After the keyboard pops up, pull it away from the screen just enough to release the tabs.
    • After the keyboard pops up, pull it away from the screen just enough to release the tabs.

    • Don’t pull the keyboard out forcefully as there is still a ribbon attached to the laptop.

  7. Unlock the ZIF connector on the computer by pushing the two outside tabs toward the screen.
    • Unlock the ZIF connector on the computer by pushing the two outside tabs toward the screen.

  8. Remove the flexible ribbon from ZIF connector.
    • Remove the flexible ribbon from ZIF connector.

    • Do not pull on the ribbon to remove it from the ZIF connector.

  9. Position the laptop so that the bottom is facing upward.
    • Position the laptop so that the bottom is facing upward.

    • Remove the 3 #0 4 mm screws holding the bottom of the palm rest.

  10. Return the laptop to proper position and open the screen.
    • Return the laptop to proper position and open the screen.

    • Remove the 6 #0 4 mm screws holding in the palm rest.

  11. Gently lift the palm rest and rotate it outward so that the bottom is now facing up.
    • Gently lift the palm rest and rotate it outward so that the bottom is now facing up.

    • The ribbon attached to the track is short and extremely delicate. Use care when moving the palm rest.

  12. Lift up on the small ZIF connector and remove ribbon.
    • Lift up on the small ZIF connector and remove ribbon.

    • If ribbon seems stuck gently wiggle it to remove. Do not pull ribbon with great force.

结论

To reassemble your device, follow these instructions in reverse order.

Thomas Wong

于2012年01月20日注册

23 信誉积分

创作了2篇指南

团队

Cal Poly, Team 11-20, Maness Winter 2012 Cal Poly, Team 11-20, Maness Winter 2012 的会员

CPSU-MANESS-W12S11G20

4 名成员

创作了7篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 0

总计 771