简介

Because the latitude E6400 has just one screw to remove to access the upgradable guts, this process takes no more than 5 minutes to do. It's also very easy.

Pictures and text written by ouimetnick.

配件

无需配件。

  1. Simultaneously slide the battery latches (outlined by the red box) to the dock connector in the middle. This will release the battery. Just slide the battery away from the computer.
    • Simultaneously slide the battery latches (outlined by the red box) to the dock connector in the middle.

    • This will release the battery. Just slide the battery away from the computer.

    • Open up the computer and press and hold the power button for 5 seconds. This drains any power left inside the computer.

    • This is important, as if electricity remains in the notebook, it can shock you and damage the logic board.

  2. Loosen the center screw with a philips screw driver. This is the only screw that needs to be loosened. It can't be removed as it is captive the the bottom plate.
    • Loosen the center screw with a philips screw driver. This is the only screw that needs to be loosened.

    • It can't be removed as it is captive the the bottom plate.

    • Now slide the plate away from the dock connector.

  3. 所有超过US$100或包含 Pro Tech工具包的订单免费送货!

    浏览我们的商店
  4. Locate the RAM slot. the system can hold 2 RAM modules.
    • Locate the RAM slot.

    • the system can hold 2 RAM modules.

    • This unit has 1 module. It is a 1GB one.

    • Push the metal spreaders (shown in the blue rectangle) straight away from the RAM module.

    • The RAM module should pop up to a 45 degree angle.

  5. Pull the RAM module straight out from the way it was raised. (Once it pops up to a 45 degree angle, pull it straight out from its current position).
    • Pull the RAM module straight out from the way it was raised. (Once it pops up to a 45 degree angle, pull it straight out from its current position).

    • Insert the new RAM into the empty slot, ensuring that the notch in the RAM lines up with the slot (see picture).

  6. Slide the bottom plate on. Slide it to the rear of the notebook. (battery compartment)
    • Slide the bottom plate on.

    • Slide it to the rear of the notebook. (battery compartment)

    • tighten the screw.

    • Do not over-tighten. Doing so will strip the screw.

  7. Slide the battery in until it clicks. Press the power button.
    • Slide the battery in until it clicks.

    • Press the power button.

    • AND it works.

结论

To reassemble your device, follow these instructions in reverse order.

16等其他人完成本指南。

Nicholas Ouimet

于2009年10月16日注册

2,125 信誉积分

创作了7篇指南

I assume that in Step 4, you install the new memory modules

Peter Bourke - 回复

When/how to fit the new memory modules is unclear. I have a blue flashing A light and can't start up. Looking for solutions.

Linda - 回复

It would be helpful to add a link to troubleshooting info here

Linda - 回复

Instead of "assuming" why not READ all of Step 4; especially the second paragraph, which states: "Insert the new RAM into the empty slot, ensuring that the notch in the RAM lines up with the slot (see picture)."

Nadaword - 回复

In my case, I needed to add a second memory board (2nd memory slot). If possible, would be interesting to have this additional step included in the guide.

Pedro Pontes - 回复

添加评论

浏览统计数据:

过去的24小时: 4

过去的7天: 11

过去的30天: 45

总计 48,067