Flip your laptop over to view the bottom and locate the two locks.
  • Flip your laptop over to view the bottom and locate the two locks.

添加评论

Slide the two locks away from each other.
  • Slide the two locks away from each other.

  • Sliding these locks will loosen the battery to allow removal.

添加评论

  • Pull battery out of the laptop.

  • Your laptop's battery should be completely removed.

添加评论

  • Flip the laptop right side up. Open the laptop.

  • Gently press in the four retaining tabs along the top of the keyboard with a spudger, one at a time.

    • After the first tab is released, gently lift up on the keyboard so it doesn't lock again. Finish the other three tabs while gently lifting up on the keyboard. The keyboard will hinge up along the bottom.

添加评论

  • Gently flip the data cable latch away from the data cable with flat side of spudger.

  • Lift the cable up and out.

  • When reinstalling cable, there are two retainer wings on the sides of the cable that the cable that lock onto the bottom of the cable latch area. When these are in place the cable is properly inserted.

  • For removing the optical drive you don't need to disconnect the keyboard ribbon cable.

What do I do is i broke the cable retainer wings and the black thing?

Wezley Joao Ferreira - 回复

If the connector on the motherboard is still attached and only the clip is broken you can try and find a new clip, or perhaps tape the keyboard in place with electrical tape.

Tyler - 回复

  • Close the lid, flip the laptop bottom side up with the battery at the top.

  • Remove the 11 screws holding the upper case to the lower case.

添加评论

  • Flip the laptop over and open the lid.

  • Remove the two screws from the upper case.

添加评论

  • Gently unplug the power cable.

    • You lift up on the dark gray latch.

    • Pull the blue ribbon up.

  • Gently unplug the touchpad cable.

    • Lift up on the dark gray latch.

    • Pull the blue ribbon up

添加评论

  • Grab the metal frame of the upper case and gently pull it away from the lower case. Disconnect the cable that says MB before removing the palmrest.

  • Work your way around the perimeter of the upper case.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

7等其他人完成本指南。

Tyler

于2012年06月19日注册

4,024 信誉积分

创作了18篇指南

团队

TechForce TechForce 的会员

Business

2 名成员

创作了18篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 3

过去的30天: 21

总计 2,286