简介

Follow this guide to remove the LCD Display.

配件

无需配件。

Insert a spludger into the notch at the far left side of the top blue panel and pry hinge cover off.
  • Insert a spludger into the notch at the far left side of the top blue panel and pry hinge cover off.

  • Note: You may need to pry the other side off by inserting the spludger between the hinge and the top cover.

  • Be careful of wire attached to underside of the hinge cover.

添加评论

Pull the small black tab on the right hand side of the laptop.
  • Pull the small black tab on the right hand side of the laptop.

  • The hinge cover has now been removed.

添加评论

  • Flip the laptop over and remove the indicated screws.

  • Flip the laptop back over.

  • Find the two places where the display module is attached to the base of the computer.

添加评论

  • Disconnect the video card from the display module by gently lifting upwards on the black tab.

添加评论

  • Lift the display module directly upwards from the base of the computer.

添加评论

  • The display module has been removed.

添加评论

  • First, remove the plastic tabs that are covering the interior screws.

  • After removing the tabs, remove the interior screws using a #1 Philips Screwdriver.

  • Note there are 8 tabs and 8 screws in total.

添加评论

  • Now that the screws are removed, press the plastic casing inward to loosen the case. Then remove the plastic case from the monitor unit.

添加评论

  • Using a Philips #1 screwdriver remove the screws holding the LCD in place.

  • Note there are 8 screws in total for this step, 4 on each side of the unit.

添加评论

  • Remove the broken LCD unit, and replace with new unit.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

2等其他人完成本指南。

Perry

于2011年04月12日注册

248 信誉积分

创作了4篇指南

团队

Cal Poly, Team 18-22, Garner Spring 2011 Cal Poly, Team 18-22, Garner Spring 2011 的会员

CPSU-GARNER-S11S18G22

4 名成员

创作了16篇指南

which controller board do i have to use for this model ?

bcdoor - 回复

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 1

过去的30天: 3

总计 4,315