Dell Inspiron 1750 Screen Replacement

简介

This guide is useful for replacing a damaged or malfunctioning screen.

Separate the screws by size and head type. Be sure to keep them in a safe place.
Remove the sixteen 2mm Phillips #00 screws from the bottom of the laptop.
Remove the two 2mm Phillips #0 screws from the hard drive port.

Keep your hand pressed firmly on the back panel to prevent it from falling.
Flip the laptop over horizontally and open up the lid.
Insert the tip of the plastic opening tool into the upper left corner of the panel.
Keeping its tip under the top panel, slide the plastic opening tool around the panel until the panel is completely loose. Next gently remove the panel.
Remove the four 2mm Phillips #0 screws at the top of the keyboard.
Slide the plastic opening tool around the keyboard until the keyboard is completely loose. Gently remove the keyboard.

Do not lift the keyboard completely free to avoid damaging its connections to the laptop interior.
Locate the small black latch attached to blue tape.
Lift the small latch with your finger and pull the blue tape from its port.
Slide the keyboard away from the mousepad and set it aside.

Always pull wires from their plastic ends, not their cables, to avoid wire damage.
Locate the three wires in the top left corner of the metal panel.
Use the spudger to push the two cables out of their ports.
Pull the blue tab directly up to remove middle wire.

Always pull wires from their plastic ends, not their cables, to avoid wire damage.
Gently remove the three grey wires from the metal tabs.
Insert the tip of the plastic opening tool into the bottom left corner of the panel.
Keeping its tip under the top panel, slide the plastic opening tool around the panel until the panel is completely loose.
Gently lift off the top metal panel.

Use the spudger to lift the wires from their connections.
Remember to pull wires from their plastic ends, not their cables, to avoid wire damage.
Flip the laptop over and pull the connections through until they are free from the laptop interior.

Remove the four 2mm Phillips #0 screws from the sides of the screen.
Remove the side railings from both sides of the screen by pulling the railings gently away from the screen.