跳转到主内容

简介

The screen is an essential piece of hardware that, due to its delicate and large profile, is often damaged. In this guide, we will show you how to replace the screen on the Dell Inspiron 1526 Laptop.

  1. Slide the unlock button to the left to release the battery. Slide the battery away from the laptop to remove. The unlock button is located on the bottom of the laptop.
    • Slide the unlock button to the left to release the battery.

    • Slide the battery away from the laptop to remove.

    • The unlock button is located on the bottom of the laptop.

  2. Loosen the two 3.5mm Phillips #1 screws in the battery bay.
    • Loosen the two 3.5mm Phillips #1 screws in the battery bay.

  3. Flip the laptop over.
    • Flip the laptop over.

    • Lift the control cover by prying the right side of the cover with an iFixit opening tool.

  4. Carefully lift the control cover up and forward to reveal a single ribbon cable.
    • Carefully lift the control cover up and forward to reveal a single ribbon cable.

  5. Use tweezers to squeeze the tabs on the connector and remove the ribbon cable.
    • Use tweezers to squeeze the tabs on the connector and remove the ribbon cable.

  6. Remove the control cover. Remove the control cover.
    • Remove the control cover.

  7. Remove the two 3mm Phillips #1 screws at the top of the keyboard where the control cover was.
    • Remove the two 3mm Phillips #1 screws at the top of the keyboard where the control cover was.

  8. Lift the keyboard gently from the top, but do not remove completely.
    • Lift the keyboard gently from the top, but do not remove completely.

    • Looking under the keyboard, towards the touch-pad in the center, lift up the black tab on the connector with tweezers for the keyboard ribbon cable.

  9. Remove the keyboard. Remove the keyboard.
    • Remove the keyboard.

  10. Remove the six plastic pads around the bezel using an iFixit opening pick. Remove the six 3mm Phillips #0 screws under each pad.
    • Remove the six plastic pads around the bezel using an iFixit opening pick.

    • Remove the six 3mm Phillips #0 screws under each pad.

  11. Open the computer so that it rests flat on the table. Separate the bezel from the black plastic frame using a spudger. There are a dozen snaps around the perimeter of the bezel and there are two between the pivot joints of the laptop.
    • Open the computer so that it rests flat on the table.

    • Separate the bezel from the black plastic frame using a spudger.

    • There are a dozen snaps around the perimeter of the bezel and there are two between the pivot joints of the laptop.

  12. Remove the two 3mm Phillips #1 screws at the bottom of the display panel. Lift the display slightly from the top, then pull outwards.
    • Remove the two 3mm Phillips #1 screws at the bottom of the display panel.

    • Lift the display slightly from the top, then pull outwards.

    • Flip the display panel around to the back.

    • Disconnect the connector and remove the ribbon cable.

结论

To reassemble your device, follow these instructions in reverse order.

Ahmed Alshamsi

于2019年09月17日注册

181 信誉积分

创作了2篇指南

0条评论

添加评论

浏览统计数据:

过去的24小时: 1

过去的7天: 1

过去的30天: 6

总计 72