简介

As laptop motherboards age, they have a chance to fail and may need to be replaced. Make sure the motherboard is at room temperature and not near any hazardous materials that could melt or destroy the motherboard during the removal process.

Remove the battery to avoid electrical discharge while working with this system.
  • Remove the battery to avoid electrical discharge while working with this system.

  • Flip the laptop over.

  • Slide the latches toward the edges to unlock the battery.

  • Lift the battery out of the laptop.

添加评论

Loosen the two screws on the access panel using the PH1 head screwdriver.
  • Loosen the two screws on the access panel using the PH1 head screwdriver.

  • Pry the access panel open with the spudger.

添加评论

  • Remove the memory card by pulling apart the latches holding it in place.

添加评论

  • Remove the nine 8.65mm screws holding the backplate to the laptop using the PH0 head screwdriver.

  • Remove the four 1.22 mm screws holding the backplate to the laptop using the PH0 head screwdriver.

添加评论

  • Depress (push in, not down) the five tabs at the top of the keyboard and the two on each side of the keyboard using a flat head screwdriver.

  • Pry the keyboard from the laptop using the spudger.

  • Be careful when lifting out the keyboard because there is a cable connecting it to the laptop.

添加评论

  • Lift the latch holding down the cable using a flat head screwdriver.

  • Slide the cable out.

  • This will free the keyboard from the laptop.

添加评论

  • Disengage both antenna (black and white) cables by lifting them up using the spudger.

  • Unscrew the one 8.65 mm screw holding the wireless card.

  • Remove the wireless card.

添加评论

  • Lift the locking tab with the spudger and pull the cable form the locking tab.

  • Repeat with the second locking tab.

添加评论

  • Remove the four 8.65 mm screws underneath the keyboard plate.

  • Remove the three 1.22 mm small screws underneath the keyboard plate.

添加评论

  • Separate the palmrest from the base of the laptop using the spudger to loosen the palmrest along the edges.

  • Make sure to remove all the screws, especially the inconspicuous 8.65 mm screw next to the hard drive.

添加评论

  • Remove the cables on the upper left side of the laptop using flat tweezers.

  • Remove the cable from the upper right hand corner.

添加评论

  • Remove the speaker cable.

  • Remove cable on the right-hand side.

添加评论

  • Unscrew the one 8.65 mm screw holding the motherboard in place with a PH0 size head screwdriver.

  • Remove the motherboard.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

Kody Dahlke

于2018年02月15日注册

671 信誉积分

创作了5篇指南

团队

USF Tampa, Team S1-G5, Leahy Spring 2018 USF Tampa, Team S1-G5, Leahy Spring 2018 的会员

USFT-LEAHY-S18S1G5

5 名成员

创作了5篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 4

过去的30天: 15

总计 125