跳转到主内容

简介

This is a simple step-by-step guide on how to remove and replace a screen display for a Dell Inspiron 13-5368. You will need a Philips Head J-0 screwdriver and a pry tool in order to perform this task. This is a relatively easy task and will take about 8 minutes to complete.

  1. Remove the nine 6mm Phillips #0 screws that secure the back cover of the laptop. Remove the nine 6mm Phillips #0 screws that secure the back cover of the laptop.
    • Remove the nine 6mm Phillips #0 screws that secure the back cover of the laptop.

  2. Use a spudger to pry up and remove the back cover. Use a spudger to pry up and remove the back cover.
    • Use a spudger to pry up and remove the back cover.

  3. Remove the four 3mm Phillips #0 screws at the corners of the battery that secure it to the laptop.
    • Remove the four 3mm Phillips #0 screws at the corners of the battery that secure it to the laptop.

  4. Pull the battery cable's black tab towards the battery to disconnect it from the motherboard.
    • Pull the battery cable's black tab towards the battery to disconnect it from the motherboard.

    • Pull the tab parallel to the motherboard, not straight up.

  5. Remove the battery. Remove the battery.
    • Remove the battery.

  6. Unscrew the four screws securing the heatsink and remove it. Remember to reapply a small amount of thermal paste, then screw the heatsink onto the motherboard in numberical order (i.e. 1, 2, 3, 4).
    • Unscrew the four screws securing the heatsink and remove it.

    • Remember to reapply a small amount of thermal paste, then screw the heatsink onto the motherboard in numberical order (i.e. 1, 2, 3, 4).

结论

Remember to clean off any old thermal paste, then apply a small amount of new thermal paste (dime size will be fine). Screw the heatsink on in numerical order so the thermal paste is evenly distributed on the processor. To reassemble your device, follow these instructions in reverse order.

另外一个人完成了本指南。

Matt Sugrim

于2017年09月27日注册

913 信誉积分

创作了6篇指南

团队

USF Tampa, Team S14-G6, Boczar Fall 2017 USF Tampa, Team S14-G6, Boczar Fall 2017 的会员

USFT-BOCZAR-F17S14G6

4 名成员

创作了6篇指南

Is it normal for the heatsink to be loose right in front of the fan? The black part of the heatsink?

JRaje - 回复

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 3

过去的30天: 6

总计 400