简介

Use this guide to replace a damaged display bezel.

Lay the monitor screen-down so the back screws are exposed.
  • Lay the monitor screen-down so the back screws are exposed.

  • Remove the four 11.9 mm Phillips #2 screws securing the stand to the back of the monitor.

添加评论

Gently lift and pull away the stand at a slight angle away from the monitor.
  • Gently lift and pull away the stand at a slight angle away from the monitor.

添加评论

  • Locate the two holes on the bottom of the monitor.

  • Insert a plastic opening tool or spudger into the holes and gently pry the plastic apart along the groove.

  • This task is much easier if two people pry simultaneously at each hole.

  • Continue prying along the entire edge of the monitor.

添加评论

  • When finished prying, the plastic will partially fall away from the rest of the monitor.

  • Do not try to fully remove the front frame yet. The frame is still attached to the buttons.

  • While holding the frames together, carefully flip the monitor over so it faces screen down.

  • Gently lift and remove remove the rear case from the monitor.

添加评论

  • Locate the green interface button board.

  • Remove the three 9.71 mm Phillips #2 screws holding the interface button board to the display bezel.

  • Lift the monitor interior away from the front cover.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

4等其他人完成本指南。

Mackenzie Keane

于2011年10月04日注册

475 信誉积分

创作了5篇指南

团队

Cal Poly, Team 5-36, Amido Fall 2011 Cal Poly, Team 5-36, Amido Fall 2011 的会员

CPSU-AMIDO-F11S5G36

4 名成员

创作了6篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 2

过去的30天: 14

总计 3,221