简介

You will not be able to access the lens without following these steps. Removing the lens does not take a lot of force since it is on a hinge and should lift out easily. However, none of the items you come in contact with leading up to the lens removal are sturdy so don't be afraid to use some force.

  1. Flip the device and lay flat.
    • Flip the device and lay flat.

    添加评论

  2. Remove the four (9 mm) screws with a PH2 screwdriver.
    • Remove the four (9 mm) screws with a PH2 screwdriver.

    • Remove the two (7 mm) located with a PH2 screwdriver.

    添加评论

    • Flip the device over and pry the top off with a plastic opening tool.

    添加评论

    • Remove the ribbon cable connecting the motherboard to the button control board by gently pulling it from its connector.

    添加评论

    • Remove four (6 mm) screws connecting the motherboard using a J0 screwdriver.

    添加评论

    • Remove the two cables connected to the motherboard: black power cable and the red/black fan cable.

    • the black cable requires more force to remove than the other cables.

    添加评论

    • Lift the black latch on the ZIF connector and remove the ribbon cable that attaches the digitizer to the motherboard.

    添加评论

    • Raise motherboard by lifting sideways and then up to avoid the ports.

    添加评论

    • Remove wires attaching the piezoelectric speakers to the motherboard.

    添加评论

    • Remove the five screws securing the black plastic cover with a J0 screwdriver.

    • Lift up and out to remove.

    添加评论

    • The lamp does not need to be removed for this step to be preformed.

    添加评论

    • Detach the keystone adjuster from the lens housing.

    • Lens is on a hinge so it should lift off easily, if it doesn't, adjust by swaying it forward or backward.

    添加评论

    • Remove the rubber foot and warranty sticker found underneath the device.

    添加评论

    • Remove the two screws on the bottom of the device with a J0 screwdriver.

    添加评论

    • Remove the focus-adjustment ring from the lens housing.

    添加评论

结论

To reassemble your device, follow these instructions in reverse order.

Andrea Espinosa

于2018年02月15日注册

433 信誉积分

创作了3篇指南

团队

USF Tampa, Team S16-G2, Boczar Spring 2018 USF Tampa, Team S16-G2, Boczar Spring 2018 的会员

USFT-BOCZAR-S18S16G2

5 名成员

创作了5篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 9

过去的30天: 49

总计 289