Skip to main content

Parts

No parts specified.

  1. Remove the two 9.65 mm screws on the back cover using the Philips head PH00 screw driver.
    • Remove the two 9.65 mm screws on the back cover using the Philips head PH00 screw driver.

  2. Remove the back casing to expose the circuit board.
    • Remove the back casing to expose the circuit board.

  3. Detach the gray antenna wires by gently pulling on the side closest to the circuit board.
    • Detach the gray antenna wires by gently pulling on the side closest to the circuit board.

  4. Detach the speaker wire by gently pulling on the side closest to the body of the camera.
    • Detach the speaker wire by gently pulling on the side closest to the body of the camera.

  5. Remove the two 4.35 mm screws on the circuit board using the Philips head PH00 screw driver.
    • Remove the two 4.35 mm screws on the circuit board using the Philips head PH00 screw driver.

  6. Detach the white plug by gently pulling on the black wires. Detach the white plug by gently pulling on the black wires.
    • Detach the white plug by gently pulling on the black wires.

  7. Remove the circuit board to expose the camera body. At the same time, you will need to feed the wires through the circuit board and out the slot in the black plate under the circuit board.
    • Remove the circuit board to expose the camera body.

    • At the same time, you will need to feed the wires through the circuit board and out the slot in the black plate under the circuit board.

  8. Gently pull on the grey wire to detach the microphone from the camera body. Gently pull on the grey wire to detach the microphone from the camera body.
    • Gently pull on the grey wire to detach the microphone from the camera body.

  9. Detach the microphone from the circuit board by gently pulling on the grey wire. Detach the microphone from the circuit board by gently pulling on the grey wire. Detach the microphone from the circuit board by gently pulling on the grey wire.
    • Detach the microphone from the circuit board by gently pulling on the grey wire.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Stanley DeLuna-Dabrowski

Member since: 2018年03月21日

133 Reputation

1 Guide authored

Team

IUPUI, Team S4-G2, Baechle Spring 2018 Member of IUPUI, Team S4-G2, Baechle Spring 2018

IUPUI-BAECHLE-S18S4G2

3 Members

6 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 6

All Time: 212