Crosley CR704 Drive Belt Replacement

本指南有最近更改，您可查看未经巡查的最新版本。

简介

The Crosley CR704 turntable is belt driven. This means the motor that spins your records is attached to the platter via a belt.

If you can hear the motor under your turn table working, but the platter won't spin, you may need to adjust or replace your drive-belt. Follow these easy steps to do so.

你所需要的

步骤 1 Safety

Crosley CR704 Drive Belt Replacement, Safety: 步骤 1 中的图像 1，1

Unplug power cable (if it's plugged in) so you don't electrocute yourself (or loved ones).
Secure tone arm so it doesn't hurt itself (or you).

翻译

步骤 2

Using a flat edge (such as a spudger or a flathead screwdriver) pry the C-clamp from the center spindle by wedging the flat edge between the spindle and the C-clamp.
The C-clamp may pop off unexpectedly, so be careful it doesn't fall somewhere hard to reach.
The C-clamp his what holds the platter in place. With it removed, you can now et under the platter.

翻译

步骤 3

You can now lift the platter.
The drive-belt will be found either around the bottom of the platter or around the motor.
If the drive-belt is broken it will need to be replaced. If it is loose, you can simply re-secure it.

翻译

Belt is fine. Motor won't spin.

paul simmons - 2023年2月13日回复

What size belt do I need

Chuck Devlin - 2023年6月25日回复

步骤 4

To replace the belt, wrap it around the inner circle of the bottom of the platter. Then stretch the belt around one of the two pegs found near the outer edge of the bottom of the platter.
This will be a snug fit, so be careful not to snap the rubber belt!

翻译

Please include a picture for this step thank you!

Bill Payne - 2018年10月7日回复

步骤 5

Using your thumb as a guide, place the platter back onto the motor so that the peg holding the drive-belt wraps around the outside of the brass motor post.

翻译

步骤 6

Secure the platter all the way down and spin the platter clockwise until you hear a pop and feel resistance from the drive-belt catching.

翻译

步骤 7

You can replace the C-clamp by shoving it back into place around the center spindle (this will require some force).
It's not necessary to replace the C-clamp unless you plan on moving the device around.

翻译