跳转到主内容

修复你的物品

维修的权力

商店

简介

This guide will show how to replace the barrel heating element of your Conair Infiniti PRO Curling Iron. It requires the housing, power cord and motherboard to be removed beforehand.

  1. Remove the Philips #1 28 mm.
    • Remove the Philips #1 28 mm.

    • Make sure device is unplugged and cool before attempting to replace parts.

  2. Remove the Philips #1 22 mm screws.
    • Remove the Philips #1 22 mm screws.

  3. Pry off the housing using a plastic spudger. Pry off the housing using a plastic spudger. Pry off the housing using a plastic spudger.
    • Pry off the housing using a plastic spudger.

  4. Pull power chord out.
    • Pull power chord out.

  5. Heat up your soldering gun and desolder the red wire from the motherboard as shown.
    • Heat up your soldering gun and desolder the red wire from the motherboard as shown.

    • Note the location of wire attachment.

  6. With your soldering gun, desolder the white wire from the motherboard as shown.
    • With your soldering gun, desolder the white wire from the motherboard as shown.

    • Note the location of wire attachment.

  7. Once both wires are desoldered the motherboard can be removed.
    • Once both wires are desoldered the motherboard can be removed.

  8. Remove the heating element mount. This will free up the heating element barrel for replacement. Remove the heating element mount. This will free up the heating element barrel for replacement.
    • Remove the heating element mount. This will free up the heating element barrel for replacement.

结论

To reassemble your device, follow these instructions in reverse order.

2等其他人完成本指南。

Jonathon Bruer

于2017年11月09日注册

580 信誉积分

创作了5篇指南

团队

IUPUI, Team S7-G5, Baechle Fall 2017 IUPUI, Team S7-G5, Baechle Fall 2017 的会员

IUPUI-BAECHLE-F17S7G5

3 名成员

创作了5篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 3

过去的30天: 16

总计 828