简介

You are going to be starting from the handle and working your way to the head of the dryer in this disassembly.

配件

无需配件。

  1. Unscrew the two 18 mm long Phillips #2 screws on the side of the hair dryer.
    • Unscrew the two 18 mm long Phillips #2 screws on the side of the hair dryer.

    添加评论

  2. Some pieces may fall out when removing the face of the handle.
    • Some pieces may fall out when removing the face of the handle.

    • Once you have taken the screws out, take the top half of the handle off by lifting it off of the dryer.

    添加评论

    • Remove the inner white disk piece by gently pulling it out with your finger nail.

    添加评论

    • Gently remove the tan boxes (power supply) by wiggling them out of place and set them aside so you can take the back part of the handle off.

    添加评论

  3. 传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Remove the inner white disk piece from the base of the dryer head by gently pulling it out with your finger nail.

    添加评论

    • Unscrew the three 12 mm long Phillips #2 screws to remove the back of the hairdryer.

    添加评论

    • Once the three screws are removed, pop the back of the dryer off by wiggling it until it comes loose. This shouldn't take too much effort.

    添加评论

    • At this point, unwind the cord and lay it to the side so you can get to the screw in the middle easier.

    • Remove the single 12 mm long Phillips #2 screw in the middle of the cord track.

    添加评论

    • Take off the white cap that covers the heating coil. You will see a wound up piece of metal (cord retracting coil) underneath once the cap is removed.

    添加评论

    • When removing the coil, make sure it stays wound up. It could very easily pop out, and you would have to wind it all the way back up and try to squeeze it back into the slot when you reassemble the dryer.

    • To remove the coil, use your screw driver to pop the coil out of the slot.

    • This is what the coil would look like if it came undone when you removed it.

    添加评论

    • Once the coil is removed, unscrew the three 11 mm long Phillips #2 screws underneath to remove the retracting wheel.

    添加评论

结论

To reassemble your device, follow these instructions in reverse order.

Candace

于2014年01月23日注册

884 信誉积分

创作了7篇指南

团队

Cal Poly, Team 10-33, Maness Winter 2014 Cal Poly, Team 10-33, Maness Winter 2014 的会员

CPSU-MANESS-W14S10G33

3 名成员

创作了7篇指南

添加评论

浏览统计数据:

过去的24小时: 2

过去的7天: 13

过去的30天: 86

总计 3,333