Press the eject button to view the laser inside.
  • Press the eject button to view the laser inside.

  • Using the blue plastic tool and the tweezers, remove the ribbon cable.

添加评论

Remove the six 1cm screws on the bottom of the device with the Phillips #1 screwdriver.
  • Remove the six 1cm screws on the bottom of the device with the Phillips #1 screwdriver.

  • Do not lift the top of the DVD player too quickly because there are wires attached on the inside.

  • Pry the top of the device open from the right side where the buttons are located.

添加评论

  • When pulling the ribbon cables out, make sure not to pull by the wires, as this can cause damage to them.

  • Pinch the plastic adapter with two fingers to remove the wires circled in red from the circuit board.

添加评论

  • Remove the two 6.35mm screws circled in black with a #1 Philips head screwdriver.

  • Remove one 4mm screw circled in red with a #1 Philips head screwdriver.

添加评论

  • There are three small 4.5mm springs that can be easily lost. Be careful when lifting up the railing assembly to make sure you don't lose them.

  • The location of the springs are circled.

  • Using two plastic tool removers, lift the two rails up at an angle. Keep the rods angled as shown.

  • The rail at the top of the picture is 82mm and the rail at the bottom of the picture is 65mm.

添加评论

  • Be careful not to lose the spring at the top of the laser.

  • Lift the laser assembly out of the fixture.

添加评论

  • Remove the rails from the disk reader.

  • Once the top rail is removed, the white gear will come off and under it will be one of the springs.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

另外一个人完成了本指南。

Yufay Chow

于2012年01月23日注册

92 信誉积分

创作了4篇指南

团队

Cal Poly, Team 10-36, Amido Winter 2012 Cal Poly, Team 10-36, Amido Winter 2012 的会员

CPSU-AMIDO-W12S10G36

4 名成员

创作了7篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 1

过去的30天: 4

总计 557