1. Flip the keyboard upside down so the bottom is angled towards you.
    • Flip the keyboard upside down so the bottom is angled towards you.

    添加评论

  2. Use a #2 Phillips screwdriver to remove the twenty-seven 12 mm screws from the dark gray bottom panel.
    • Use a #2 Phillips screwdriver to remove the twenty-seven 12 mm screws from the dark gray bottom panel.

    添加评论

    • Remove the bottom panel by lifting the bottom panel up and outward from yourself.

    添加评论

    • Flip the entire keyboard so the keys face up, and be careful not to let the bottom drop.

    • Flip the top half of the keyboard and set onto the bottom half with the internal parts facing up.

    添加评论

    • Plug in the soldering iron and place somewhere safe to avoid burning yourself or causing a fire.

    • Completely unscrew and remove all four screws in the corners of the speaker.

    添加评论

    • Pull the speaker out of the keyboard and set on a flat surface to solder safely.

    添加评论

    • Be careful when removing the wires and avoid dripping solder on yourself or the keyboard.

    • Touch soldering iron to solder over the end of the wires, and when the solder melts, pull the wires away from the speaker.

    • Remove the speaker and replace with a new one.

    添加评论

    • Strip the wires if you need more clean metal to solder to the speaker.

    • Use the soldering iron to melt the solder over the wire to connect them to the speaker.

    添加评论

    • Completely screw in the screws back into the original positions on the corner of the speaker.

    添加评论

结论

To reassemble your device, follow these instructions in reverse order.

另外一个人完成了本指南。

Jimmy Winne

于2012年10月04日注册

446 信誉积分

创作了6篇指南

团队

Cal Poly, Team 9-16, Amido Fall 2012 Cal Poly, Team 9-16, Amido Fall 2012 的会员

CPSU-AMIDO-F12S9G16

4 名成员

创作了6篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 9

过去的30天: 35

总计 3,739