简介

You will need a #00 Phillips screwdriver to replace the camera's casing.

Make sure to remove the batteries before beginning the guide.

配件

无需配件。

Turn the camera to the side that has the attachment for the wrist strap.
  • Turn the camera to the side that has the attachment for the wrist strap.

    • Unscrew the two black 3.4 mm screws with a #00 Phillips screwdriver.

添加评论

Remove the plastic subsection by prying it with your fingers.
  • Remove the plastic subsection by prying it with your fingers.

    • Note: It may be helpful to pry from the bottom of the camera with the battery door open.

    • The wrist strap attachment behind the subsection will come loose and may fall out.

添加评论

  • Turn the camera over to the side opposite of the wrist strap.

    • Remove the two silver 3.4 mm screws with a #00 Phillips screwdriver.

添加评论

  • Flip the camera upside down.

  • Remove the following screws with a #00 Phillips screwdriver.

    • One black 3.4 mm Phillips screw.

    • One silver 3.4 mm Phillips screw.

      • NOTE: Using your fingernails may help in removal.

添加评论

  • Place the camera on the side opposite of the wrist strap handle.

  • Then begin to pry the casing apart with both hands by applying pressure to the top and bottom of the camera.

    • Remove the small metal plate underneath the plastic covering and set aside. (It should be loosely attached)

  • Note: A rubber foam washer that separates the lens from the casing will fall off when the case is removed. Be sure to store it safely.

  • Note: When reassembling ensure the back plate screw tabs are over the wrist strap attachment and the front plate screw tabs go under orange casing.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

5等其他人完成本指南。

Memphis Wong

于2010年09月30日注册

73 信誉积分

撰写一个指南

团队

Cal Poly, Team 14-37, Forte Fall 2010 Cal Poly, Team 14-37, Forte Fall 2010 的会员

CPSU-FORTE-F10S14G37

4 名成员

创作了6篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 1

过去的30天: 3

总计 3,405