跳转到主内容

配件

没有特定配件。

  1. Remove the two 3.1mm screws from the bottom of the camera.
    • Remove the two 3.1mm screws from the bottom of the camera.

    • The display screen of the camera should be facing towards you.

  2. With the screen facing you, rotate the camera counter clock-wise onto it's side.
    • With the screen facing you, rotate the camera counter clock-wise onto it's side.

    • Remove the two 3.1mm screws.

  3. With the screen still facing you, rotate the camera 180 degrees.
    • With the screen still facing you, rotate the camera 180 degrees.

    • The side with the charging port should now be facing up.

  4. Use the tool (or fingers) to pry open the charging port cover. Rotate the cover so that you have access to the screw underneath.
    • Use the tool (or fingers) to pry open the charging port cover.

    • Rotate the cover so that you have access to the screw underneath.

    • Remove both 3.1mm screws.

    • The image still shows the screw from step 3 in place.

  5. Turn the camera so the bottom is once again facing up. With the battery door still open, use a spudger to remove the cover from the front of the camera.
    • Turn the camera so the bottom is once again facing up.

    • With the battery door still open, use a spudger to remove the cover from the front of the camera.

  6. Pull off the the front cover.
    • Pull off the the front cover.

    • Be careful not to break the tabs that hold it in place.

  7. Use the spudger to remove the back cover. Be careful not to break the tabs. Be careful not to break the tabs.
    • Use the spudger to remove the back cover.

    • Be careful not to break the tabs.

结论

To reassemble your device, follow these instructions in reverse order.

3等其他人完成本指南。

Jacob

于2015年03月17日注册

477 信誉积分

创作了3篇指南

团队

Michigan Tech, Team 1-10, Lauer Spring 2015 Michigan Tech, Team 1-10, Lauer Spring 2015 的会员

MTU-LAUER-S15S1G10

2 名成员

创作了5篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 12

总计 907