简介

Remove the back cover before removing LCD.

配件

无需配件。

Remove one 2.25mm screw on the bottom.
  • Remove one 2.25mm screw on the bottom.

添加评论

Remove two 2.25mm screws on the right side looking from the front.
  • Remove two 2.25mm screws on the right side looking from the front.

添加评论

Remove one 4.7mm screw on the side with the AV output.
  • Remove one 4.7mm screw on the side with the AV output.

添加评论

Pull off the back cover.
  • Pull off the back cover.

  • The back cover tends to stick in the top corner (near the mode dial) due to a metal clip. Jiggle the cover side to side as you pull it out.

添加评论

Remove 2 2.4mm screws on bottom.
  • Remove 2 2.4mm screws on bottom.

添加评论

Follow the small data cable to where it connects to the camera.
  • Follow the small data cable to where it connects to the camera.

  • Lift the back white portion to unlock the cable.

  • The cable should easily slide out.

  • The connector is very fragile. Use caution when lifting the lock.

添加评论

Gently lift LCD display off.
  • Gently lift LCD display off.

  • There will be two data cables still attached to the camera. Do not break them.

  • There may be a loose strip of metal along the inner side of the LCD display for a secure fit.

添加评论

Follow the larger cable to where it connects to the camera.
  • Follow the larger cable to where it connects to the camera.

  • Lift the front black portion of the connector to unlock the data cable.

  • The cable should easily slide out.

  • The connector is very fragile. Use caution when lifting the lock.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

2等其他人完成本指南。

Jeremy Rabaino

于2010年10月10日注册

135 信誉积分

创作了6篇指南

团队

Cal Poly, Team 20-9, Maness Fall 2010 Cal Poly, Team 20-9, Maness Fall 2010 的会员

CPSU-MANESS-F10S20G9

5 名成员

创作了6篇指南

where can I buy a replacement LCD screen for a SD800 IS

ALFRED - 回复

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 1

总计 2,075