跳转到主内容

Canon PowerShot SD700 Backlight Replacement

你所需要的

  1. Canon PowerShot SD700 Backlight Replacement, Outside Case: 步骤 1 中的图像 1,1
    • Turn off the camera by pressing the power button above the LCD screen.

  2. Canon PowerShot SD700 Backlight Replacement: 步骤 2 中的图像 1,1
    • Remove the two, small screws on the bottom of the camera using a Phillip's #00 screwdriver.

  3. Canon PowerShot SD700 Backlight Replacement: 步骤 3 中的图像 1,1
    • Use a Phillips #00 screwdriver to remove the two, small screws on the right side of the camera.

  4. Canon PowerShot SD700 Backlight Replacement: 步骤 4 中的图像 1,1
    • Use a Phillips #00 screwdriver to remove the screw on the left of the camera under the A/V out Digital label.

  5. Canon PowerShot SD700 Backlight Replacement: 步骤 5 中的图像 1,1
    • Use a Phillips #00 screwdriver, remove the screw on the bottom of the camera near the battery and memory card slots.

    • This screw will be longer than the rest of the screws.

  6. Canon PowerShot SD700 Backlight Replacement: 步骤 6 中的图像 1,1
    • Remove the front, back, and side casings from the camera and set to the side.

  7. Canon PowerShot SD700 Backlight Replacement, LCD screen: 步骤 7 中的图像 1,1
    • Remove the two screws that connect the LCD and backlight to the main body of the camera.

  8. Canon PowerShot SD700 Backlight Replacement: 步骤 8 中的图像 1,3 Canon PowerShot SD700 Backlight Replacement: 步骤 8 中的图像 2,3 Canon PowerShot SD700 Backlight Replacement: 步骤 8 中的图像 3,3
    • Gently pry the LCD and the backlight from the main body of the camera.

    • Gently pry the LCD from the backlight.

    • The thin ribbon cable is for the backlight.

    • The thick ribbon cable is for the LCD screen.

  9. Canon PowerShot SD700 Backlight Replacement: 步骤 9 中的图像 1,1
    • Carefully lift the ZIF connector that covers the thick ribbon cable.

    • This ZIF connector is fragile. Use caution when lifting it from its down position.

    • Insert the new LCD and reassemble the camera.

  10. Canon PowerShot SD700 Backlight Replacement, Backlight: 步骤 10 中的图像 1,1
    • Unplug the ribbon from the housing on the circuitry.

    • Take the new ribbon and insert it into the housing.

    • Tweezers or a tool with a sharp point can be used.

结论

To reassemble your device, follow these instructions in reverse order.

Emilio Rossi

于04/07/11注册

113 声望

创作了3篇指南

团队

Cal Poly, Team 9-71, Walters Spring 2011 Cal Poly, Team 9-71, Walters Spring 2011 的会员

CPSU-WALTERS-S11S9G71

4 名成员

创作了9篇指南

0条评论

添加评论

浏览统计数据:

过去 24 小时: 0

过去 7 天: 0

过去 30 天: 4

总计 1,606