简介

Follow these instructions to remove and install a new backlight.

Turn off camera by pressing power button above the LCD screen.
  • Turn off camera by pressing power button above the LCD screen.

  • Remove the battery and memory card.

添加评论

Remove the screws on the bottom of the camera using a 00 Philip's head screw driver
  • Remove the screws on the bottom of the camera using a 00 Philip's head screw driver

添加评论

Remove the screws on the right side of the camera.
  • Remove the screws on the right side of the camera.

添加评论

Remove the screws on the left of the camera underneath the "A/V out Digital" cover flap.
  • Remove the screws on the left of the camera underneath the "A/V out Digital" cover flap.

添加评论

Mac RAM Kits
Speed up your Mac. Max out its memory.
Mac RAM Kits
Get more memory out of your Mac.
Remove the screws on the bottom of the camera near the battery and the memory card slots.
  • Remove the screws on the bottom of the camera near the battery and the memory card slots.

  • This screw is longer than the rest of the screws.

添加评论

Remove the front back and side casings from the camera.
  • Remove the front back and side casings from the camera.

添加评论

Remove the two screws that connect the LCD and backlight to the main body of the camera.
  • Remove the two screws that connect the LCD and backlight to the main body of the camera.

添加评论

Gently pry the LCD and the backlight from the main body of the camera. Gently pry the LCD from the backlight. The thin ribbon cable is for the backlight.
  • Gently pry the LCD and the backlight from the main body of the camera.

  • Gently pry the LCD from the backlight.

    • The thin ribbon cable is for the backlight.

    • The thick ribbon cable is for the LCD screen.

添加评论

Carefully lift the ZIF connector that covers the thick ribbon cable.
  • Carefully lift the ZIF connector that covers the thick ribbon cable.

  • This ZIF connector is fragile. Use caution when lifting it from its down position.

  • Insert the new LCD and reassemble the camera.

添加评论

Unplug the ribbon from the housing on the circuitry.
  • Unplug the ribbon from the housing on the circuitry.

  • Take the new ribbon and insert it into the housing.

    • Tweezers or a tool with a sharp point can be used.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

Emilio Rossi

于2011年04月07日注册

113 信誉积分

创作了3篇指南

团队

Cal Poly, Team 9-71, Walters Spring 2011 Cal Poly, Team 9-71, Walters Spring 2011 的会员

CPSU-WALTERS-S11S9G71

4 名成员

创作了8篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 0

总计 1,480