Canon PowerShot SD1200 IS LCD Replacement

Jeff Casper 和 5 其他贡献者

最后更新于 May 7, 2024

5分钟

中等

详尽分析

简介

转到步骤 1

Removing the LCD screen seems intimidating, but everything comes apart rather easily. You just have to lift tabs, remove a single screw and lift out the screen.

你所需要的

工具

步骤 1 Front and Rear Covers

Canon PowerShot SD1200 IS LCD Replacement, Front and Rear Covers: 步骤 1 中的图像 1，1

Remove the battery.

编辑

步骤 2

Canon PowerShot SD1200 IS LCD Replacement: 步骤 2 中的图像 3，3

Remove the two screws from the side of the camera casing with the strap. (4mm Phillips 00)
Remove the two screws from the bottom of the camera. (4mm Phillips 00)
Remove the two screws from the right side of the camera opposite the strap. (2mm Phillips 00)

编辑

步骤 3

Pull off the front cover.
If the top of the cover sticks, use gentle downward pressure on the retention clips above the lens to release.
Remove the back cover.

编辑

步骤 4 LCD

Canon PowerShot SD1200 IS LCD Replacement, LCD: 步骤 4 中的图像 1，3

Canon PowerShot SD1200 IS LCD Replacement, LCD: 步骤 4 中的图像 2，3

Canon PowerShot SD1200 IS LCD Replacement, LCD: 步骤 4 中的图像 3，3

在这个步骤中使用的工具：

Tweezers

$4.99

添加到购物车

Use the spudger to lift the retaining flap on the Zero Insertion Force (ZIF) tab securing the thick ribbon cable.
Slide out the ribbon cable using fingers or tweezers.
Be sure you are prying up on the hinged retaining flap, not the connector.
Using tweezers, disconnect the small ribbon cable below the flash assembly from the No Fuss Connector by simply pulling the ribbon cable straight out.

编辑

步骤 5

Canon PowerShot SD1200 IS LCD Replacement: 步骤 5 中的图像 3，3

Remove the L shaped brackets from the left and right side of the LCD screen with the spudger tool.
The Brackets have tabs that need to be pried up.
Remove the screw below the shutter button. (2.5mm Phillips 00)
Holding the sides of the LCD screen, lift the screen up and away to remove.