简介

Use this guide to replace the Canon Powershot A75's casing.

配件

无需配件。

Turn the camera over and locate the "BATT OPEN" sliding switch.
  • Turn the camera over and locate the "BATT OPEN" sliding switch.

添加评论

Slide the switch to the right.
  • Slide the switch to the right.

    • The battery cover should slide down and spring open.

添加评论

  • Remove the 4 AA batteries.

    • Watch for the orientation of the batteries as they slide out.

    • The battery orientation is shown under the battery flap itself and on a sticker next to the battery flap.

添加评论

  • Remove the three 2.5mm screws on the bottom of the camera.

添加评论

  • Remove the 3.8mm screw underneath the flap that covers the A/V port.

添加评论

  • Remove the 2.4mm screw located underneath the cover of the memory card slot.

添加评论

  • Open the memory card slot by sliding it laterally until you hear a click.

  • Remove the 5.9mm screw in the upper corner of the memory card slot.

添加评论

  • Remove the two 4.1mm screws at the bottom of the battery flap.

添加评论

  • Lift the shutter button and speaker part from the top of the camera.

    • DO NOT pull the part too hard because there is a plug connecting the speaker to the camera.

添加评论

  • Using a pair of tweezers, grab the plug that connects the speaker to the camera and gently pull it out.

添加评论

  • Remove the rightmost 4.2mm screw underneath the battery cover, not the center screw.

添加评论

  • Separate the back casing and front casing of the camera using your hands.

    • Pulling the two halves apart can be difficult, especially at the top. Use a moderate amount of force.

添加评论

  • On the front of the camera, press the button on the lower left of the lens.

  • Twist the outer lens casing counter-clockwise and slide it out.

添加评论

  • Take off the front casing.

  • There is a black rubber washer around the lens that comes out after you take the casing off. Make sure to replace it when putting the camera back together.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

4等其他人完成本指南。

Andrew Elliott

于2012年04月12日注册

13 信誉积分

撰写一个指南

团队

Cal Poly, Team 17-30, Amido Spring 2012 Cal Poly, Team 17-30, Amido Spring 2012 的会员

CPSU-AMIDO-S12S17G30

5 名成员

创作了6篇指南

Thank you for this detailed guide. It helped me to gain access to the electrical contacts in the battery compartment to remove alkaline battery corrosion

Jef B - 回复

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 1

总计 786