简介

This guide shows you how to install the top panel of the camera.

Using a #00 Phillips screw driver, remove three 4.4 mm Phillips screws as indicated by the red circles.
  • Using a #00 Phillips screw driver, remove three 4.4 mm Phillips screws as indicated by the red circles.

添加评论

Using your finger, peel back the textured grip so the components are separated.
  • Using your finger, peel back the textured grip so the components are separated.

添加评论

  • Using the flat end of a spudger, loosen the connection between the front panel and the device.

  • Remove the front panel using your hands.

添加评论

  • Turn Camera over.

  • Using a #00 Phillips screw driver, unscrew the two 4.9 mm Phillips screws located on either side of the viewfinder.

添加评论

  • Using a #00 Phillips screw driver, unscrew the one 5.7 mm Phillips screw located next to the LCD screen.

添加评论

  • Lay the camera on its back.

  • Unsolder the flash connection from the motherboard as noted by the blue circle.

添加评论

  • Remove the top panel by lifting it from the back, pushing it forward over the camera and letting it rotate down in front of the camera.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

另外一个人完成了本指南。

Zach

于2012年04月04日注册

40 信誉积分

创作了8篇指南

团队

Cal Poly, Team 14-9, Forte Spring 2012 Cal Poly, Team 14-9, Forte Spring 2012 的会员

CPSU-FORTE-S12S14G9

5 名成员

创作了12篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 8

总计 1,395