简介

This guide shows you how to install a new lens connector.

配件

无需配件。

Using a #00 Phillips screw driver, remove three 4.4 mm Phillips screws as indicated by the red circles.
  • Using a #00 Phillips screw driver, remove three 4.4 mm Phillips screws as indicated by the red circles.

添加评论

Using your finger, peel back the textured grip so the components are separated. Using your finger, peel back the textured grip so the components are separated.
  • Using your finger, peel back the textured grip so the components are separated.

添加评论

Using the flat end of a spudger, loosen the connection between the front panel and the device. Remove the front panel using your hands. Remove the front panel using your hands.
  • Using the flat end of a spudger, loosen the connection between the front panel and the device.

  • Remove the front panel using your hands.

添加评论

Using a Phillips #00 screwdriver, remove the 5 indicated screws
  • Using a Phillips #00 screwdriver, remove the 5 indicated screws

    • Five 6.2 mm Phillips screws

添加评论

Using your hands, remove the top black ring.
  • Using your hands, remove the top black ring.

  • WARNING! The indicated piece is spring loaded. Prepare for it to eject when taking off top ring.

    • Spring located here.

添加评论

There are two silver metal rings. Remove the top silver metal ring.
  • There are two silver metal rings.

  • Remove the top silver metal ring.

添加评论

Remove the bottom silver ring.
  • Remove the bottom silver ring.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

2等其他人完成本指南。

Zach

于2012年04月04日注册

40 信誉积分

创作了8篇指南

团队

Cal Poly, Team 14-9, Forte Spring 2012 Cal Poly, Team 14-9, Forte Spring 2012 的会员

CPSU-FORTE-S12S14G9

5 名成员

创作了12篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 3

总计 1,376