1. Remove the eyecup by gently pushing it upwards, so it doesn't block us in the final step of pulling the back casing from the camera's body.
    • Remove the eyecup by gently pushing it upwards, so it doesn't block us in the final step of pulling the back casing from the camera's body.

  2. Remove the three 1/8" philips screws from the bottom of the back casing
    • Remove the three 1/8" philips screws from the bottom of the back casing

  3. Open the CF card compartment by moving it upwards and tilting it away from the camera body.
    • Open the CF card compartment by moving it upwards and tilting it away from the camera body.

    • Remove the two 3/16" philips screws besides the CF card slot opening.

  4. Remove the black screws from the camera's left rubber covering - note it is a 5/16" screw at the top and a 3/16" screw at the bottom.
    • Remove the black screws from the camera's left rubber covering - note it is a 5/16" screw at the top and a 3/16" screw at the bottom.

  5. 所有超过US$100或包含 Pro Tech工具包的订单免费送货!

    浏览我们的商店
  6. Aided by a screwdriver or plastic opening tool, remove the rubber coating from the left side of the camera.
    • Aided by a screwdriver or plastic opening tool, remove the rubber coating from the left side of the camera.

  7. With a pointy tool, remove the soft cap covering the screw.
    • With a pointy tool, remove the soft cap covering the screw.

    • Remove the 3/16" philips screw.

  8. Use a plastic opening tool to help detaching the back casing from the camera's body.
    • Use a plastic opening tool to help detaching the back casing from the camera's body.

  9. Carefully lift the back casing from the camera's body from left to right.
    • Carefully lift the back casing from the camera's body from left to right.

  10. Locate the connector which holds the flat cable to the main circuit board. Unlock the connector by gently pulling  up its black piece from the side the flat cable comes into it. Pull the flat cable from the connector and you'll have completely removed the back casing from the camera. Note I taped each of the screws to their original places on the removed back casing, so I don't loose or mix any of them.
    • Locate the connector which holds the flat cable to the main circuit board. Unlock the connector by gently pulling up its black piece from the side the flat cable comes into it.

    • Pull the flat cable from the connector and you'll have completely removed the back casing from the camera.

    • Note I taped each of the screws to their original places on the removed back casing, so I don't loose or mix any of them.

  11. Remove the three 1/8" philips screws holding the LCD chassis to the camera's body.
    • Remove the three 1/8" philips screws holding the LCD chassis to the camera's body.

  12. Remove the power cable from the main board. Unlock the flat cable connector by pulling out its black edges. Pull out the flat cable  from the connector on the main board.
    • Remove the power cable from the main board.

    • Unlock the flat cable connector by pulling out its black edges.

    • Pull out the flat cable from the connector on the main board.

结论

To reassemble your device, follow these instructions in reverse order.

2等其他人完成本指南。

Claudio Felix

于2016年01月01日注册

692 信誉积分

创作了7篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 3

过去的30天: 6

总计 1,259