简介

This fix is safe and only requires a screwdriver.

配件

无需配件。

  1. Remove the two 4.8 mm black screws above the lens on the front of the camera.
    • Remove the two 4.8 mm black screws above the lens on the front of the camera.

    添加评论

  2. Remove the 4.3 mm black screw under the lens ring, and the 4.8 mm black screw under the camera.
    • Remove the 4.3 mm black screw under the lens ring, and the 4.8 mm black screw under the camera.

    添加评论

    • Remove the 4.8 mm black screw on the left side of the camera.

    添加评论

    • Remove the front panel by lifting it away from the camera's body.

    添加评论

    • Remove seven 4.25 mm black screws on the bottom panel.

    添加评论

    • Remove the bottom panel.

    添加评论

  3. 订单满 $20 免运费
    结账时使用优惠码 BLUEANDBLACK
    订单满 $20 免运费
    使用优惠码 BLUEANDBLACK
    • Remove two 6.5 mm black screws from the panel.

    添加评论

    • Remove the plastic remote control socket cap by pulling it straight out.

    添加评论

    • Slide panel toward bottom of camera to remove.

    添加评论

    • Slide the outer eyepiece upward to remove it.

    添加评论

    • Remove the two 4.75 mm black screws located on the top of the camera.

    添加评论

    • Remove the four 4.3 mm black screws near the bottom corners of the eyepiece at the back of the camera.

    添加评论

    • Slowly separate the top panel from the camera by pushing it upward.

    • Separating the top panel too far or quickly can damage the ribbon cable and connecting wires that are still attached to the top panel of the camera.

    添加评论

    • Remove the two 5.5 mm screws from front of camera.

    添加评论

    • Remove grip panel.

    添加评论

    • Remove one black screw from battery door on underside of grip.

    添加评论

    • Remove battery door.

    添加评论

结论

To reassemble your device, follow these instructions in reverse order.

另外一个人完成了本指南。

Jackie

于2011年04月17日注册

218 信誉积分

创作了3篇指南

团队

Cal Poly, Team 8-8, Regan Spring 2011 Cal Poly, Team 8-8, Regan Spring 2011 的会员

CPSU-REGAN-S11S8G8

5 名成员

创作了11篇指南

I was able to complete this by going from step 9 to 15. Oddly, I only had one screw to remove in step 15 but the grip piece easily slid out without needing to remove the top of the camera.

Alan - 回复

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 2

过去的30天: 8

总计 3,216