跳转到主内容

Blu Studio 5.5 S Rear Facing Camera Replacement

你所需要的

  1. Blu Studio 5.5 S Rear Facing Camera Replacement, Back Casing: 步骤 1 中的图像 1,1
    • In order to remove the back case, start by flipping the phone to the back side and look at it from the top.

  2. Blu Studio 5.5 S Rear Facing Camera Replacement, Applying Pressure: 步骤 2 中的图像 1,3 Blu Studio 5.5 S Rear Facing Camera Replacement, Applying Pressure: 步骤 2 中的图像 2,3 Blu Studio 5.5 S Rear Facing Camera Replacement, Applying Pressure: 步骤 2 中的图像 3,3
    • Place your finger in the small notch on the left side of the charging port (facing from the back).

    • Once your finger is in the notch, pull the back case towards yourself to remove it.

  3. Blu Studio 5.5 S Rear Facing Camera Replacement, Battery: 步骤 3 中的图像 1,3 Blu Studio 5.5 S Rear Facing Camera Replacement, Battery: 步骤 3 中的图像 2,3 Blu Studio 5.5 S Rear Facing Camera Replacement, Battery: 步骤 3 中的图像 3,3
    • Once the back case is removed, locate the battery. It is the large brick embedded in the phone. It has BLU Products, a caution statement, and a barcode on it.

    • Insert your finger into the notch near the lower left of the battery, apply pressure and lift up.

  4. Blu Studio 5.5 S Rear Facing Camera Replacement, Midframe: 步骤 4 中的图像 1,3 Blu Studio 5.5 S Rear Facing Camera Replacement, Midframe: 步骤 4 中的图像 2,3 Blu Studio 5.5 S Rear Facing Camera Replacement, Midframe: 步骤 4 中的图像 3,3
    • The speaker is located behind the inner back case. Using a Phillips #0 screwdriver, unscrew the 10, 7mm screws.

    • Using the Phillips #00 screwdriver, unscrew the two, 10mm screws at the bottom.

  5. Blu Studio 5.5 S Rear Facing Camera Replacement, Aesthetic Bottom Case: 步骤 5 中的图像 1,1
    • Apply pressure and pop off the bottom aesthetic case, being careful not to break it.

  6. Blu Studio 5.5 S Rear Facing Camera Replacement: 步骤 6 中的图像 1,3 Blu Studio 5.5 S Rear Facing Camera Replacement: 步骤 6 中的图像 2,3 Blu Studio 5.5 S Rear Facing Camera Replacement: 步骤 6 中的图像 3,3
    • Use the Spudger to pop the inner back casing off. Do this by lightly raising the side of the battery housing, then sliding the Spudger around the case.

    • Pick up the inner back case and flip it over.

  7. Blu Studio 5.5 S Rear Facing Camera Replacement, Back Camera.: 步骤 7 中的图像 1,3 Blu Studio 5.5 S Rear Facing Camera Replacement, Back Camera.: 步骤 7 中的图像 2,3 Blu Studio 5.5 S Rear Facing Camera Replacement, Back Camera.: 步骤 7 中的图像 3,3
    在这个步骤中使用的工具:
    Tweezers
    $4.99
    购买
    • The rear camera is located in the center of the motherboard . It is connected by a ribbon wire / prong system.

    • Use tweezers to gently pop off the prong system, by pulling upwards on the black cap piece connected to the motherboard from the ribbon wire.

    • Use the Tweezers to pull the camera out of the housing.

    • When removing the back camera be careful not to scratch the lens, unless you are throwing it out.

结论

To reassemble your device, follow these instructions in reverse order.

另外一个人完成了本指南。

Cody Dyl

于10/27/14注册

804 声望

创作了5篇指南

团队

UMass Dartmouth, Team 4-8, Miles Fall 2014 UMass Dartmouth, Team 4-8, Miles Fall 2014 的会员

UMASSD-MILES-F14S4G8

2 名成员

创作了6篇指南

0条评论

添加评论

浏览统计数据:

过去 24 小时: 0

过去 7 天: 0

过去 30 天: 6

总计 1,500