1. We did not have an actual back cover or battery for the phone we were given. Therefore, the first couple of steps will be without pictures.
    • We did not have an actual back cover or battery for the phone we were given. Therefore, the first couple of steps will be without pictures.

    • Hold the phone with the back side facing you.

    • Press down on the silver tab towards the bottom end of the phone.

    • Carefully lift up the back casing to reveal the battery.

  2. Put your finger on the top left corner of the battery and lift the battery up and out of its housing.
    • Put your finger on the top left corner of the battery and lift the battery up and out of its housing.

    • The phone should now look like this.

  3. Remove the two top screws using a T5 Torx screwdriver.
    • Remove the two top screws using a T5 Torx screwdriver.

  4. 所有超过US$100.00或包含 Pro Tech工具包的订单免费送货!

    浏览我们的商店

    善于维修,即天赋异禀。

    与 #ImAGenius 分享您的维修故事

    我们都是天才

    与 #ImAGenius 分享您的维修故事

  5. Use a plastic opening tool to pry the edges of the bottom cover until it snaps loose. The cover will now pull off easily.
    • Use a plastic opening tool to pry the edges of the bottom cover until it snaps loose.

    • The cover will now pull off easily.

  6. Use a plastic opening tool to pry between the front and back cover. Start prying from wherever it is easiest to separate the silver and black plastic of the covers.
    • Use a plastic opening tool to pry between the front and back cover.

    • Start prying from wherever it is easiest to separate the silver and black plastic of the covers.

    • There are 5 securing clips on the front panel to disconnect.

    • Pry gently to prevent breaking the plastic clips when removing the front panel.

    • Once all the clips have been freed, the front cover will lift away from the phone.

  7. Lift the flexible keypad away from the device. It should come off easily.
    • Lift the flexible keypad away from the device. It should come off easily.

  8. Use a T6 Torx Screwdriver to remove the four corner screws on the keyboard's housing. Lift the keyboard frame away from the device.
    • Use a T6 Torx Screwdriver to remove the four corner screws on the keyboard's housing.

    • Lift the keyboard frame away from the device.

    • There may be a small amount of adhesive at the bottom of the frame that needs to be pulled away.

  9. Use a plastic opening tool to pry the trackball housing from the keyboard housing.
    • Use a plastic opening tool to pry the trackball housing from the keyboard housing.

  10. Remove the trackball from the silver trackball housing by hand.
    • Remove the trackball from the silver trackball housing by hand.

结论

To reassemble your device, follow these instructions in reverse order.

Nhan Le

于2012年04月03日注册

27 信誉积分

撰写一个指南

团队

Cal Poly, Team 14-11, Forte Spring 2012 Cal Poly, Team 14-11, Forte Spring 2012 的会员

CPSU-FORTE-S12S14G11

5 名成员

创作了5篇指南

浏览统计数据:

过去的24小时: 1

过去的7天: 2

过去的30天: 7

总计 5,061