We did not have an actual back cover or battery for the phone we were given. Therefore, the first couple of steps will be without pictures.
  • We did not have an actual back cover or battery for the phone we were given. Therefore, the first couple of steps will be without pictures.

  • Hold the phone with the back side facing you.

  • Press down on the silver tab towards the bottom end of the phone.

  • Carefully lift up the back casing to reveal the battery.

添加评论

Put your finger on the top left corner of the battery and lift the battery up and out of its housing.
  • Put your finger on the top left corner of the battery and lift the battery up and out of its housing.

  • The phone should now look like this.

添加评论

  • Remove the two top screws using a T5 Torx screwdriver.

添加评论

  • Use a plastic opening tool to pry the edges of the bottom cover until it snaps loose.

  • The cover will now pull off easily.

添加评论

  • Use a plastic opening tool to pry between the front and back cover.

  • Start prying from wherever it is easiest to separate the silver and black plastic of the covers.

  • There are 5 securing clips on the front panel to disconnect.

  • Pry gently to prevent breaking the plastic clips when removing the front panel.

  • Once all the clips have been freed, the front cover will lift away from the phone.

添加评论

  • Lift the flexible keypad away from the device. It should come off easily.

添加评论

  • Use a T6 Torx Screwdriver to remove the four corner screws on the keyboard's housing.

  • Lift the keyboard frame away from the device.

  • There may be a small amount of adhesive at the bottom of the frame that needs to be pulled away.

添加评论

  • Detach each side casing by pulling them off gently from the phone.

添加评论

  • Remove the back housing from the mother board.

添加评论

  • Unhook the screen frame from the small tab at the top of the motherboard.

添加评论

  • Using a plastic opening tool, detach the connector on the LCD screen from the motherboard.

  • There may be some adhesive behind the LCD screen. If needed, pry the LCD screen away from the motherboard using the plastic opening tool.

  • Remove the LCD screen from the motherboard

添加评论

  • Once the LCD screen is taken off, the motherboard is fully separated from the device.

  • The picture shown is the back side of the motherboard.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

Joshua Ramos

于2012年04月04日注册

65 信誉积分

创作了2篇指南

团队

Cal Poly, Team 14-11, Forte Spring 2012 Cal Poly, Team 14-11, Forte Spring 2012 的会员

CPSU-FORTE-S12S14G11

5 名成员

创作了5篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 2

总计 2,121