简介

If the rear speaker on your Blackberry 7520 is broken, look here to install a new one.

Turn the phone upside down. Push down on the black button on the back of the phone to slide the rear panel off.
  • Turn the phone upside down.

  • Push down on the black button on the back of the phone to slide the rear panel off.

  • The battery should be visible now.

添加评论

Hold the BlackBerry in one hand face-up with the screen facing towards you. Gently smack the phone against your hand to dislodge the battery. Gently smack the phone against your hand to dislodge the battery.
  • Hold the BlackBerry in one hand face-up with the screen facing towards you.

  • Gently smack the phone against your hand to dislodge the battery.

添加评论

Use a T6 Torx screwdriver to remove the six screws located on the rear of the phone. Use a T6 Torx screwdriver to remove the six screws located on the rear of the phone.
  • Use a T6 Torx screwdriver to remove the six screws located on the rear of the phone.

添加评论

Mac RAM Kits
Speed up your Mac. Max out its memory.
Mac RAM Kits
Get more memory out of your Mac.
Use a pick or plastic iPod opening tool to push the clips, that are holding the rear casing. Apply a firm pressure at a forty-five degree angle to dislodge the clips. Applying too much pressure could break the plastic clips and permanently damage the casing, so be careful.
  • Use a pick or plastic iPod opening tool to push the clips, that are holding the rear casing. Apply a firm pressure at a forty-five degree angle to dislodge the clips.

  • Applying too much pressure could break the plastic clips and permanently damage the casing, so be careful.

添加评论

Repeat the  process of unlatching the clips for the top section of the Blackberry.
  • Repeat the process of unlatching the clips for the top section of the Blackberry.

添加评论

Do not try to pull the two pieces apart. You may tear the antenna cable.  Instead, fold the two pieces open to avoid stress on the cable.
  • Do not try to pull the two pieces apart. You may tear the antenna cable. Instead, fold the two pieces open to avoid stress on the cable.

添加评论

Separating the two halves allows you to access the speaker. Which is located in the front half of the case.
  • Separating the two halves allows you to access the speaker. Which is located in the front half of the case.

添加评论

Insert a plastic opening tool between the speaker and the case. Then pry the speaker out. To reinsert the speaker, align the blue notch to the blue stud. Then the red notch to the red stud. As shown in the last picture. To reinsert the speaker, align the blue notch to the blue stud. Then the red notch to the red stud. As shown in the last picture.
  • Insert a plastic opening tool between the speaker and the case. Then pry the speaker out.

  • To reinsert the speaker, align the blue notch to the blue stud. Then the red notch to the red stud. As shown in the last picture.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

Nathan

于2010年01月18日注册

31 信誉积分

创作了7篇指南

团队

Cal Poly, Team 5-7, Forte Winter 2010 Cal Poly, Team 5-7, Forte Winter 2010 的会员

CPSU-FORTE-W10S5G7

5 名成员

创作了7篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 0

总计 2,372