跳转到主内容

简介

Need to get inside your Blackberry Storm to fix it? Or just want to salvage parts? This is an easy to follow guide to do it!

配件

没有特定配件。

  1. Have a cracked screen? Need to replace your speaker? Etc? Well just follow these steps.
    • Have a cracked screen? Need to replace your speaker? Etc? Well just follow these steps.

  2. Turn your Storm where the battery door is facing up. Remove the battery door. Remove the battery.
    • Turn your Storm where the battery door is facing up.

    • Remove the battery door.

    • Remove the battery.

  3. Remove the two hex screws as shown by the SIM card slot.
    • Remove the two hex screws as shown by the SIM card slot.

  4. iPhone 电池维修工具包

    只要 $29.99

    Buy Now

    iPhone 电池维修工具包

    只要 $29.99

    Buy Now
  5. Remove the plastic piece that covers the camera & flash on the back . This is held in with some tape so use a safe pry tool. Remove the two hex screws underneath it.
    • Remove the plastic piece that covers the camera & flash on the back . This is held in with some tape so use a safe pry tool.

    • Remove the two hex screws underneath it.

  6. Turn the phone over and remove the plastic cover under the buttons as shown. Remove the 2 screws underneath. Remove the 2 screws underneath.
    • Turn the phone over and remove the plastic cover under the buttons as shown.

    • Remove the 2 screws underneath.

  7. Go around your device with the plastic pry tool, there a 3 clips on each side of the housing. There is a connection for the antenna from the front to mid housing. Remove it with a pry tool if it does not come off by itself. There is a connection for the antenna from the front to mid housing. Remove it with a pry tool if it does not come off by itself.
    • Go around your device with the plastic pry tool, there a 3 clips on each side of the housing.

    • There is a connection for the antenna from the front to mid housing. Remove it with a pry tool if it does not come off by itself.

  8. You now have 3 pieces. The rear, mid , & front housing.
    • You now have 3 pieces. The rear, mid , & front housing.

  9. To remove the screen gently pry up this ribbon cable with a pry tool. To remove the screen gently pry up this ribbon cable with a pry tool.
    • To remove the screen gently pry up this ribbon cable with a pry tool.

  10. To remove the main board from the mid housing disconnect the ribbon cable as pictured. Now follow in reverse order for reassembly! Now follow in reverse order for reassembly!
    • To remove the main board from the mid housing disconnect the ribbon cable as pictured.

    • Now follow in reverse order for reassembly!

结论

To reassemble your device, follow these instructions in reverse order.

6等其他人完成本指南。

Josh Forester

于2010年11月28日注册

2,321 信誉积分

创作了10篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 3

过去的30天: 4

总计 9,377