跳转到主内容

简介

This guide shows how to remove the side button used to browse through the menus on the RIM BlackBerry 7290.

  1. Apply pressure to the lock button on the back of the device. Slide the battery cover down towards the bottom of the device, revealing the battery compartment. Slide the battery cover down towards the bottom of the device, revealing the battery compartment.
    • Apply pressure to the lock button on the back of the device.

    • Slide the battery cover down towards the bottom of the device, revealing the battery compartment.

  2. Locate groove along the right side of the battery compartment. Remove battery by prying between the battery and the groove. Remove battery by prying between the battery and the groove.
    • Locate groove along the right side of the battery compartment.

    • Remove battery by prying between the battery and the groove.

  3. Slide the SIM card holder to the left to unlock the SIM card.
    • Slide the SIM card holder to the left to unlock the SIM card.

  4. Lift the SIM card holder up. Gently remove the SIM card from the SIM card holder by sliding the card along the railing.
    • Lift the SIM card holder up.

    • Gently remove the SIM card from the SIM card holder by sliding the card along the railing.

  5. Locate the four screws along the perimeter of the back casing.
    • Locate the four screws along the perimeter of the back casing.

    • Remove the four top screws using a T-6 torx screwdriver.

    • The top four screws are .413 inches.

  6. Locate two screws within the lower edge of the inner compartment. Remove the two bottom screws using a T-6 torx screwdriver.
    • Locate two screws within the lower edge of the inner compartment.

    • Remove the two bottom screws using a T-6 torx screwdriver.

    • The bottom two screws are .2 inches in length.

    • The second picture displays the device after the six screws have been removed.

  7. Use the plastic opening tool to apply pressure on the two clips that are located at the bottom of the phone.
    • Use the plastic opening tool to apply pressure on the two clips that are located at the bottom of the phone.

  8. Remove the back casing from the phone by lifting the unhooked portion, then slide the casing towards the top of the device. Make sure all clips holding the case together are unhooked, so no damage is caused to the case. Make sure all clips holding the case together are unhooked, so no damage is caused to the case.
    • Remove the back casing from the phone by lifting the unhooked portion, then slide the casing towards the top of the device.

    • Make sure all clips holding the case together are unhooked, so no damage is caused to the case.

  9. Locate on the backside of the phone, a screw towards the top of the device. Using a T-6 screwdriver, remove the screw.
    • Locate on the backside of the phone, a screw towards the top of the device.

    • Using a T-6 screwdriver, remove the screw.

    • After the screw has been removed, carefully lift the side button brace to reveal the side button.

结论

To reassemble your device, follow these instructions in reverse order.

Jschutt

于2009年11月05日注册

70 信誉积分

撰写一个指南

团队

Cal Poly, Team 19-6, Maness Fall 2009 Cal Poly, Team 19-6, Maness Fall 2009 的会员

CPSU-MANESS-F09S19G6

5 名成员

创作了7篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 1

过去的30天: 3

总计 3,506