简介

Upon completion of this guide, you can successfully install and replace the motor fan for you blender.

  1. Before disassembling the blender base, make sure the blender disconnected from any power outlet. Lift the jar straight up from the base without tilting the jar.
    • Before disassembling the blender base, make sure the blender disconnected from any power outlet.

    • Lift the jar straight up from the base without tilting the jar.

  2. Remove the top three 1/4 inch base screws using a Philip's head screwdriver.
    • Remove the top three 1/4 inch base screws using a Philip's head screwdriver.

  3. Remove the two base leg covers next to the power cord using pliers or a flat-head screwdriver. This provides access to the base screws beneath.
    • Remove the two base leg covers next to the power cord using pliers or a flat-head screwdriver.

    • This provides access to the base screws beneath.

  4. 所有超过US$100.00或包含 Pro Tech工具包的订单免费送货!

    浏览我们的商店

    善于维修,即天赋异禀。

    与 #ImAGenius 分享您的维修故事

    我们都是天才

    与 #ImAGenius 分享您的维修故事

  5. Remove the following screws that secure the top and  bottom halves of the base.
    • Remove the following screws that secure the top and bottom halves of the base.

      • One 1/4 Phillips screw

      • One TA-20 screw

    • Both screwdrivers must have a minimum of a three inch shank (length).

    • Screwdrivers with extenders will not fit down the access holes.

  6. Lift the top half of the base from the bottom half of the base to reveal the internal mechanism.
    • Lift the top half of the base from the bottom half of the base to reveal the internal mechanism.

  7. Using pliers, remove the top nut from the fan and remove the washer. Use a small towel to hold the fan in place. This makes taking off the nut easier to do.
    • Using pliers, remove the top nut from the fan and remove the washer.

    • Use a small towel to hold the fan in place. This makes taking off the nut easier to do.

  8. Lift the fan blades from the blender base.
    • Lift the fan blades from the blender base.

结论

To reassemble your device, follow these instructions in reverse order.

2等其他人完成本指南。

Andrew

于2012年10月04日注册

170 信誉积分

创作了4篇指南

团队

Cal Poly, Team 6-34, Regan Fall 2012 Cal Poly, Team 6-34, Regan Fall 2012 的会员

CPSU-REGAN-F12S6G34

4 名成员

创作了6篇指南

浏览统计数据:

过去的24小时: 2

过去的7天: 6

过去的30天: 24

总计 2,701