跳转到主内容

简介

This guide will show you how to replace an old worn out or dead battery in an Asus ZenBook UX303U laptop.

  1. Remove the two round rubber feet at the hinge-edge of the laptop.
    • Remove the two round rubber feet at the hinge-edge of the laptop.

  2. Remove the eleven 4 mm Phillips #00 screws from the back panel.
    • Remove the eleven 4 mm Phillips #00 screws from the back panel.

  3. Using a plastic opening tool pry the back panel off of the laptop. Using a plastic opening tool pry the back panel off of the laptop.
    • Using a plastic opening tool pry the back panel off of the laptop.

  4. Pull the speaker cable out of its four retaining clips with either your fingers, or a plastic opening tool. Pull the speaker cable out of its four retaining clips with either your fingers, or a plastic opening tool.
    • Pull the speaker cable out of its four retaining clips with either your fingers, or a plastic opening tool.

  5. Remove all seven 2 mm Phillips #00 screws from the battery. Remove all seven 2 mm Phillips #00 screws from the battery.
    • Remove all seven 2 mm Phillips #00 screws from the battery.

  6. Pull the speaker connector toward the edge of the laptop to disconnect it from its socket. Pull the speaker connector toward the edge of the laptop to disconnect it from its socket.
    • Pull the speaker connector toward the edge of the laptop to disconnect it from its socket.

  7. Lift the battery connector straight up off its socket to disconnect it from the motherboard. Do not pry on the socket itself or you risk damaging the motherboard.
    • Lift the battery connector straight up off its socket to disconnect it from the motherboard.

    • Do not pry on the socket itself or you risk damaging the motherboard.

  8. Lift the battery and speakers up and pull out to remove. Check underneath the battery for the wire assembly connecting the touchpad to the motherboard. This connection may stick to the underside of the battery. Be careful not to damage it when removing the battery.
    • Lift the battery and speakers up and pull out to remove.

    • Check underneath the battery for the wire assembly connecting the touchpad to the motherboard. This connection may stick to the underside of the battery. Be careful not to damage it when removing the battery.

  9. Remove the speakers from the old battery.
    • Remove the speakers from the old battery.

结论

To reassemble your device, follow these instructions in reverse order.

Take your e-waste to an R2 or e-Stewards certified recycler.

10等其他人完成本指南。

Dean Anderson

于2018年02月14日注册

495 信誉积分

创作了3篇指南

团队

USF Tampa, Team S3-G5, Nance Spring 2018 USF Tampa, Team S3-G5, Nance Spring 2018 的会员

USFT-NANCE-S18S3G5

3 名成员

创作了9篇指南

8条评论

hello where I can buy a UX303U battery for asus?

jeannette dreifus - 回复

hello! Where I can buy a UX303U battery for my Asus netbook?

thanks

jeannette dreifus - 回复

There are two screws holding the back panel in place. They are located below the two rubber pads at the back of the pc. They must be removed in order to open the back panel.

Dave Man - 回复

Just gone through this, but two problems surfaced. 1 it won’t connect to our usual WiFi router and can’t figure out why. Is it possible to damage the WiFi connectivity when removing battery? 2 there’s no indication of charge levels. It says 100% and doesn’t change. Thoughts?

Barny Harper - 回复

Take all that back. Went back in and battery connector hadn’t clicked in far enough. Seems to be working fine now.

Barny Harper - 回复

添加评论

浏览统计数据:

过去的24小时: 13

过去的7天: 75

过去的30天: 411

总计 22,233