简介

This guide will explain how to locate and replace the fan inside of the Asus X501A-RH31 laptop. This replacement guide will fix the cooling aspect of the computer.

  1. Turn the laptop over so that the back is facing upwards.
    • Turn the laptop over so that the back is facing upwards.

    添加评论

  2. To unlock the left tab, make sure the tab on the left has red showing.
    • To unlock the left tab, make sure the tab on the left has red showing.

    添加评论

    • To unlock the right tab, push the right slider to the left with one hand.

    • Push the battery out with the other hand.

    添加评论

    • Using the Phillips #00 screwdriver unscrew all nine screws from the bottom of the laptop.

      • The nine screws are 7 mm long, 4.5 mm in diameter.

    添加评论

    • Turn the laptop over and open the top so the keyboard is facing you.

    添加评论

    • Pry off the keyboard cover on the edge using the plastic opening tool.

    • Start from one side. Once it is lose, carry out the same procedure on the front and other side.

    • Only do little sections at a time as the keyboard may break if you attempt to take the whole thing off from a single point.

    添加评论

    • Slowly lift the keyboard upward, but do not remove completely.

    • Remove the two data cables that attach the keyboard to the motherboard.

    添加评论

    • Use tweezers to pull the white plastic piece up that is attached to the data cable.

    • Repeat this process for the big black cable as well.

    • Use caution when unlatching the data cables from the motherboard. The cables are extremely delicate and can break.

    添加评论

    • Unscrew the three screws using the Phillips #00 screwdriver.

      • The three screws are 5 mm in length, 4.2 mm in diameter.

    添加评论

    • Unscrew the three screws on the left hand side of the big motherboard.

    • This will loosen the motherboard, which will allow for better access to the cables in the next step.

      • The three screws are 5 mm in length, 4.2 mm in diameter and Phillips head screws.

    添加评论

    • Remove the connector cable attached to the bottom of the motherboard.

    • Take the black plastic spudger and press down on the lower half of the white plastic piece to remove the connector cable.

    添加评论

结论

To reassemble your device, follow these instructions in reverse order.

Christopher

于2017年10月19日注册

304 信誉积分

创作了3篇指南

团队

UMass Dartmouth, Team S3-G3, Bailey Fall 2017 UMass Dartmouth, Team S3-G3, Bailey Fall 2017 的会员

UMASSD-BAILEY-F17S3G3

3 名成员

创作了8篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 3

过去的30天: 8

总计 142