简介

The 2-in-1 touchscreen display can become unresponsive or cracked due to it being used often. If the display gets damaged or becomes unresponsive, and you determine it is not a power issue, the guide shows how to replace the entire display.

Before doing a repair or replacement make sure the laptop is fully shut off.
  • Before doing a repair or replacement make sure the laptop is fully shut off.

  • Using the JIS #0 Screwdriver, unscrew the ten 10 mm screws that hold the back casing in place

添加评论

Insert the flat edge of the opening tool in between the back casing to remove the back casing.
  • Insert the flat edge of the opening tool in between the back casing to remove the back casing.

  • Try to use the opening tool at multiple points. Lifting the back casing abruptly could damage the laptop.

添加评论

  • Using the JIS #0 Screwdriver, remove the five 3.0 mm screws that hold down the hard drive casing.

添加评论

  • Lift the hard drive up and remove the power supply cable connected to it.

  • Make sure to pull on the plastic head and not the actual wires to prevent tearing them.

添加评论

  • Disconnect the white and black wires attached to the Wi-Fi chip.

添加评论

  • Remove the two adapters connecting the display to the motherboard by pulling the black plastic straps directly upwards.

添加评论

  • Use the JIS #0 screwdriver to remove the five 5.0 mm screws connecting the display to the rest of the laptop.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

Deric Wright

于2018年02月14日注册

588 信誉积分

创作了3篇指南

团队

USF Tampa, Team S5-G5, Eyestone Spring 2018 USF Tampa, Team S5-G5, Eyestone Spring 2018 的会员

USFT-EYESTONE-S18S5G5

4 名成员

创作了5篇指南

添加评论

浏览统计数据:

过去的24小时: 1

过去的7天: 4

过去的30天: 6

总计 56