跳转到主内容

简介

The motherboard is where all of the communication happens in your laptop. Because the motherboard is such an integral part, this guide will show you how to replace it without damage.

  1. Ensure your device is powered off before starting.
    • Ensure your device is powered off before starting.

    • Flip the laptop over and remove the ten 10 mm Phillips #1 screws securing the back panel.

  2. Carefully insert a plastic opening tool under one corner of the back panel.
    • Carefully insert a plastic opening tool under one corner of the back panel.

    • Slide the tool along the seam to gently pry the panel up and away from the device.

  3. The battery is the large L-shaped block. Remove the five 5.5 mm Phillips #1 screws securing it.
    • The battery is the large L-shaped block.

    • Remove the five 5.5 mm Phillips #1 screws securing it.

  4. Using a plastic opening tool, lift the battery straight upward to remove it. There are a series of eight small wires connecting the battery to the motherboard. Make sure you gently lift the battery straight up to disconnect these wires and prevent damage.
    • Using a plastic opening tool, lift the battery straight upward to remove it.

    • There are a series of eight small wires connecting the battery to the motherboard. Make sure you gently lift the battery straight up to disconnect these wires and prevent damage.

  5. PC 笔记本电池

    An easy fix for a big power boost.

    现在开始购物

    PC 笔记本电池

    An easy fix for a big power boost.

    现在开始购物
  6. Remove the four ribbons connected to the motherboard. Remove the four ribbons connected to the motherboard.
    • Remove the four ribbons connected to the motherboard.

  7. Disconnect the five wires attached to the motherboard by pulling gently. There are three thin wires in the upper left corner. Disconnect the five wires attached to the motherboard by pulling gently. There are three thin wires in the upper left corner.
    • Disconnect the five wires attached to the motherboard by pulling gently. There are three thin wires in the upper left corner.

  8. Remove the two 5 mm Phillips  #1 screws attaching the stabilizer to the motherboard
    • Remove the two 5 mm Phillips #1 screws attaching the stabilizer to the motherboard

  9. Remove the four 5 mm Phillips #1 screws around the perimeter of the motherboard.
    • Remove the four 5 mm Phillips #1 screws around the perimeter of the motherboard.

  10. Remove the six 5 mm Phillips #1 screws securing the silver plates to the motherboard. Open the laptop approximately 1/2" to loosen the hinge and release the motherboard.
    • Remove the six 5 mm Phillips #1 screws securing the silver plates to the motherboard.

    • Open the laptop approximately 1/2" to loosen the hinge and release the motherboard.

  11. Gently lift the motherboard out and away from the laptop.
    • Gently lift the motherboard out and away from the laptop.

结论

To reassemble your device, follow these instructions in reverse order.

Mary Kounelas

于2017年09月25日注册

565 信誉积分

创作了5篇指南

团队

USF Tampa, Team S4-G1, Eyestone Fall 2017 USF Tampa, Team S4-G1, Eyestone Fall 2017 的会员

USFT-EYESTONE-F17S4G1

4 名成员

创作了5篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 2

过去的30天: 13

总计 564