跳转到主内容

简介

RAM acts as temporary storage on your device that will occasionally fault or run out of memory. If you need to replace or install new RAM on your Asus Eee PC 900, follow the directions below. Before beginning, make sure the device is powered off and is not connected to any power source.

  1. Slide the battery's locking tabs from the locked position to unlocked positions. The right tab is unlocked when a red dot is showing. The left tab will have to be held in the unlocked position in order to release the battery.
    • Slide the battery's locking tabs from the locked position to unlocked positions.

    • The right tab is unlocked when a red dot is showing.

    • The left tab will have to be held in the unlocked position in order to release the battery.

  2. Slide the battery out while holding the left locking tab in the unlocked position.
    • Slide the battery out while holding the left locking tab in the unlocked position.

  3. Identify the RAM and hard drive compartment on the back of the laptop and locate the two screws holding it in place.
    • Identify the RAM and hard drive compartment on the back of the laptop and locate the two screws holding it in place.

    • There may be a sticker covering one of the screws. If not, proceed to step 5.

  4. Remove the sticker with your hand or a tweezer.
    • Remove the sticker with your hand or a tweezer.

  5. Remove the two 4.76 mm Phillips #0 screws.
    • Remove the two 4.76 mm Phillips #0 screws.

  6. Carefully open up the cover from the bottom with a plastic opening tool.
    • Carefully open up the cover from the bottom with a plastic opening tool.

  7. Remove the back cover.
    • Remove the back cover.

  8. Identify the RAM (the bottom chip)
    • Identify the RAM (the bottom chip)

    • It is held in place by two pins

  9. Use a spudger to push the end of the small metal clip on the right towards the right.
    • Use a spudger to push the end of the small metal clip on the right towards the right.

    • Now push the end of the small metal clip on the left towards the left.

    • The RAM should pop up.

  10. Remove the RAM by pulling it upwards.
    • Remove the RAM by pulling it upwards.

结论

To reassemble your device, follow these instructions in reverse order.

5等其他人完成本指南。

Brian Carreon

于2012年01月25日注册

276 信誉积分

创作了2篇指南

团队

Cal Poly, Team 3-27, Amido Winter 2012 Cal Poly, Team 3-27, Amido Winter 2012 的会员

CPSU-AMIDO-W12S3G27

4 名成员

创作了16篇指南

添加评论

浏览统计数据:

过去的24小时: 1

过去的7天: 2

过去的30天: 13

总计 7,726