跳转到主内容

简介

The Reflective Dish is the element of the Parabolic Solar Cooker which is responsible for creating heat to cook with. The dish is shaped in a way that reflects all light hitting it toward one single focal point, allowing for the heating effect to take place.

The dish has a large diameter in order to collect as much light as possible and make cooking efficient. In fact, it's so big that it comes in six pieces that need assembling. Thus, this guide serves as a reference to show you how to properly assemble your Parabolic Dish.

配件

没有特定配件。

  1. Before you begin, be sure you have all parts and tools needed for assembly and a construction area that is at least two meters in diameter. Lay two triangular sections side-by-side with pointed edges and bases adjacent to each other.
    • Before you begin, be sure you have all parts and tools needed for assembly and a construction area that is at least two meters in diameter.

    • Lay two triangular sections side-by-side with pointed edges and bases adjacent to each other.

    • Since the sections are not flat, it is advisable to prop one end up on a box or similar object to give more stability during assembly.

  2. Use the 10 mm nuts and bolts to attach the two plates together. First, hand thread each bolt/nut pair, then use two 10 mm wrenches secure them.
    • Use the 10 mm nuts and bolts to attach the two plates together. First, hand thread each bolt/nut pair, then use two 10 mm wrenches secure them.

    • DO NOT install a nut and bolt in the THIRD hole from the center (pointed end of the section). This is where the Pipe Ring Bracket is attached later on.

  3. PC 笔记本电池

    An easy fix for a big power boost.

    现在开始购物

    PC 笔记本电池

    An easy fix for a big power boost.

    现在开始购物
  4. After firmly fastening the two sections together, return to the third hole which was left empty. In addition to a nut and bolt, you will also need a pipe ring bracket. Install the 10mm nut/bolt again but with the bolt passing through the single holed side of the bracket. Hand thread and use 10mm wrenches to tighten. Be sure the bracket is NOT installed between the edges of the dish sections.
    • After firmly fastening the two sections together, return to the third hole which was left empty. In addition to a nut and bolt, you will also need a pipe ring bracket.

    • Install the 10mm nut/bolt again but with the bolt passing through the single holed side of the bracket. Hand thread and use 10mm wrenches to tighten.

    • Be sure the bracket is NOT installed between the edges of the dish sections.

    • The direction the bracket faces does not matter.

  5. Repeat steps 2-3 until you have  assembled the entire reflective dish, complete with all six sections. Remember to install the pipe ring brackets in the correct place all the way around the reflective dish in the third hole from the center.
    • Repeat steps 2-3 until you have assembled the entire reflective dish, complete with all six sections.

    • Remember to install the pipe ring brackets in the correct place all the way around the reflective dish in the third hole from the center.

结论

To disassemble your device, follow these instructions in reverse order.

Griffin Paul

于2013年10月18日注册

385 信誉积分

创作了3篇指南

团队

Cal Poly, Team 4-30, Amido Fall 2013 Cal Poly, Team 4-30, Amido Fall 2013 的会员

CPSU-AMIDO-F13S4G30

4 名成员

创作了6篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 6

过去的30天: 9

总计 791