配件

无需配件。

Remove the three 14.3mm T7 Torx screws from the bottom of AirPort.
  • Remove the three 14.3mm T7 Torx screws from the bottom of AirPort.

添加评论

Remove the 5.1mm Phillips screw from the bottom of the AirPort. This screw is located under the identification sticker. You will have to remove the sticker or make a hole to remove it.
  • Remove the 5.1mm Phillips screw from the bottom of the AirPort. This screw is located under the identification sticker. You will have to remove the sticker or make a hole to remove it.

添加评论

  • Lift the bottom and top casing straight apart and then lift metal casing straight up from the bottom plastic casing.

添加评论

  • Unplug the black connector on the top of the metal casing by gently pulling horizontally.

添加评论

  • Remove four 1mm phillips screws from the bottom.

添加评论

  • Separate the top and bottom of the metal casing. You will now expose the motherboard and AirPort card.

  • To remove the AirPort card, gently pull the plastic tab horizontally.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

3等其他人完成本指南。

Michael Garcia

于2011年10月12日注册

369 信誉积分

创作了5篇指南

团队

Cal Poly, Team 17-15, Regan Fall 2011 Cal Poly, Team 17-15, Regan Fall 2011 的会员

CPSU-REGAN-F11S17G15

3 名成员

创作了7篇指南

Thank you so much for your guide! I was challenging myself to do it without cheating, but couldn't figure out how to release the bottom plastic layer from the main unit inside after I undid the 3 Torx screws. Thankfully you avoided me having to break the whole unit by showing where the central screw hidden beneath the S/N 3 barcode sticker was and that it was Philips not Torx, and I can now pinch the A1027 wifi card and use it in my G5, instead of relying on ageing ethernet! Bless you kind folks!

HumptyDumpty - 回复

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 2

过去的30天: 11

总计 4,510