简介

Replace a faulty antenna on the AirPort Extreme Model A1034.

  1. Remove the three 14.3mm T7 Torx screws from the bottom of AirPort.
    • Remove the three 14.3mm T7 Torx screws from the bottom of AirPort.

  2. Remove the 5.1mm Phillips screw from the bottom of the AirPort. This screw is located under the identification sticker. You will have to remove the sticker or make a hole to remove it.
    • Remove the 5.1mm Phillips screw from the bottom of the AirPort. This screw is located under the identification sticker. You will have to remove the sticker or make a hole to remove it.

  3. 所有超过US$100.00或包含 Pro Tech工具包的订单免费送货!

    浏览我们的商店
  4. Lift the bottom and top casing straight apart and then lift metal casing straight up from the bottom plastic casing. Lift the bottom and top casing straight apart and then lift metal casing straight up from the bottom plastic casing.
    • Lift the bottom and top casing straight apart and then lift metal casing straight up from the bottom plastic casing.

  5. Unplug the black connector on the top of the metal casing by gently pulling horizontally.
    • Unplug the black connector on the top of the metal casing by gently pulling horizontally.

  6. Remove the two 4mm phillips screws to remove antenna.
    • Remove the two 4mm phillips screws to remove antenna.

  7. The circuit board connected to the antenna is attached to the metal case with foam adhesive.
    • The circuit board connected to the antenna is attached to the metal case with foam adhesive.

    • Gently peel or cut the foam holding the circuit board with a knife and remove it from the AirPort.

结论

To reassemble your device, follow these instructions in reverse order.

另外一个人完成了本指南。

Michael Garcia

于2011年10月12日注册

369 信誉积分

创作了5篇指南

团队

Cal Poly, Team 17-15, Regan Fall 2011 Cal Poly, Team 17-15, Regan Fall 2011 的会员

CPSU-REGAN-F11S17G15

3 名成员

创作了7篇指南

浏览统计数据:

过去的24小时: 1

过去的7天: 3

过去的30天: 13

总计 4,200