跳转到主内容
  1. Use screwdriver to pry off the stickers marked in red to reveal the location of the 4 screws.
    • Use screwdriver to pry off the stickers marked in red to reveal the location of the 4 screws.

  2. Remove the 4 screws to continue.
    • Remove the 4 screws to continue.

  3. Pry the center of the mouse apart to separate the upper and lower housing of the boards. Pry the center of the mouse apart to separate the upper and lower housing of the boards.
    • Pry the center of the mouse apart to separate the upper and lower housing of the boards.

  4. Remove the wires from the white crimp headers. this will separate the upper and lower housing units of the mouse.
    • Remove the wires from the white crimp headers. this will separate the upper and lower housing units of the mouse.

    • Pull as far up on the wire as possible, being as careful as possible to avoid ripping the wires.

  5. Take the upper housing of the mouse and begin to remove the two screws (highlighted in red) that hold the board in place. Take the upper housing of the mouse and begin to remove the two screws (highlighted in red) that hold the board in place.
    • Take the upper housing of the mouse and begin to remove the two screws (highlighted in red) that hold the board in place.

  6. Gently remove board.
    • Gently remove board.

  7. The DPI button is the red push button highlighted in red. To remove it, flip the board over and desolder the wires highlighted in orange.
    • The DPI button is the red push button highlighted in red.

    • To remove it, flip the board over and desolder the wires highlighted in orange.

    • Replace component with new component and resolder back in place.

结论

To reassemble your device, follow these instructions in reverse order.

Colin

于2014年02月10日注册

349 信誉积分

创作了3篇指南

团队

Cal Poly, Team 1-39, Maness Winter 2014 Cal Poly, Team 1-39, Maness Winter 2014 的会员

CPSU-MANESS-W14S1G39

4 名成员

创作了8篇指南

添加评论

浏览统计数据:

过去的24小时: 3

过去的7天: 6

过去的30天: 25

总计 2,304