简介
Use this guide to replace the 4-in-1 WiFi/Bluetooth/FM/GPS board on the Amazon Echo Dot 2nd generation. The 4-in-1 is located on the motherboard, so the whole board must be replaced, rather than replacing each individual component.
你所需要的
-
-
Power off and unplug the echo
-
Using the plastic opening tool, peel off the rubber layer on the bottom of the echo
-
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
7等其他人完成本指南。
2条评论
Where can I find the part my dot won’t connect and I have been going crazy trying to find the motherboard
Ivy Bowman - 回复
I wish to recommend not removing the adhesive layer if you plan to reassemble this Echo Dot. I would suggest poking holes to reach the four screws instead. Then reassembly can reuse the same adhesive layer.
rayramirez - 回复