简介

The alarm unit is located behind the glove box. Once the glovebox is out of the way, you can remove the black plastic alarm unit, open it and change the dip switch for a less sensitive setting.

配件

无需配件。

  1. Once the glove box is out of the way, it's easy to spot the alarm unit. The green connector will be plugged into it. I had already unplugged it when I took this picture.
    • Once the glove box is out of the way, it's easy to spot the alarm unit. The green connector will be plugged into it. I had already unplugged it when I took this picture.

  2. 所有超过US$100或包含 Pro Tech工具包的订单免费送货!

    浏览我们的商店
  3. It may be stubborn to get out because it is stuck down with double stick foam pads.
    • It may be stubborn to get out because it is stuck down with double stick foam pads.

  4. Remove the 4 screws (may be under the foam strips). This is the bottom of the circuit board.
    • Remove the 4 screws (may be under the foam strips). This is the bottom of the circuit board.

  5. Turn the board over and locate the 2 position dip switch.
    • Turn the board over and locate the 2 position dip switch.

    • This dip switch adjusts the glass breakage microphone sensitivity

    • Sensitivity settings:

    • 1 off & 2 off = high

    • 1 on & 2 off = mid (factory setting)

    • 1 off & 2 on = low

    • 1 on & 2 on = super low

结论

To reassemble your device, follow these instructions in reverse order.

3等其他人完成本指南。

mpeeples

于2010年04月04日注册

184 信誉积分

撰写一个指南

添加评论

浏览统计数据:

过去的24小时: 2

过去的7天: 2

过去的30天: 7

总计 1,854