简介

This guide will show you how to adjust the height of the handle bars and align the stem with the front wheel.

配件

无需配件。

  1. Remove the bolt cover with a flathead screwdriver.
    • Remove the bolt cover with a flathead screwdriver.

    添加评论

  2. 传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
  3. Loosen the goose-neck (adjustable quill stem) with a 6 mm Allen wrench.
    • Loosen the goose-neck (adjustable quill stem) with a 6 mm Allen wrench.

    • After loosening the goose-neck (adjustable quill stem), it still may be stiff. Hold the wheel from turning and twist the handlebars from side to side.

    • If quill stem is still stuck then place 6 mm Allen wrench firmly into bolt and tap with a mallet.

    • Position the handlebars to your preferred height. Make sure not to pull cable and housing to tight. I could adversely effect shifting and braking performance.

    • Make sure you don't raise quill stem above minimum insert line.

    添加评论

    • Align the direction of the goose-neck (adjustable quill stem) with the front tire.

    • Firmly tighten the goose-neck (adjustable quill stem) bolt using a 6 mm Allen wrench.

    • Pop the bolt cover back on.

    • If calling a bicycle repair shop, refer to it as a adjustable quill stem (technical term) instead of goose-neck as mechanic may not know what you are talking about.

    添加评论

终点

另外一个人完成了本指南。

aaron thielk

于2010年10月10日注册

1,723 信誉积分

创作了5篇指南

团队

Cal Poly, Team 5-13, Maness Fall 2010 Cal Poly, Team 5-13, Maness Fall 2010 的会员

CPSU-MANESS-F10S5G13

4 名成员

创作了11篇指南

Anyone know where/how to buy a replacement bolt cover?

Bennett Hart - 回复

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 1

过去的30天: 11

总计 7,842