简介

If the display is malfunctioning on your Acer Aspire V5-122P-0468 laptop follow this guide to replace it yourself.

  1. Remove the nine 4mm screws with a PH0 screwdriver.
    • Remove the nine 4mm screws with a PH0 screwdriver.

    • Remove the two 6mm screws with a PH0 screwdriver.

    添加评论

  2. Remove the black rubber tab on the back of the computer
    • Remove the black rubber tab on the back of the computer

    • Remove the 4mm screw hidden underneath the black tab with a PH0 screwdriver.

    添加评论

    • Orient the computer upside down, with the hinges facing away from you.

    • Find the black plastic piece in the SD card slot on the right side of the computer.

    • Remove the plastic piece by sliding it out of the SD card slot.

    添加评论

    • Insert a spudger at these eight locations to disengage the plastic tabs from the housing cover, and pry apart.

      • Continue around the entire perimeter of the cover with the spudger.

    • Use a spudger to pry the cover around I/O ports.

    添加评论

    • Remove the two 4mm screws using a PH0 screwdriver.

    • Depress the tabs holding the battery with a spudger.

    • Disconnect the battery connector from the motherboard using a spudger.

    • Pull the battery up and away from the laptop to remove.

    添加评论

    • Flip up the black locking tab on the ZIF connector, and pull out the ribbon cable.

    添加评论

    • Wedge a spudger in between the plastic bezel frame and back cover to create a gap.

    • Then insert a plastic opening tool to pry apart the bezel from the back cover.

    • Work your way around the perimeter of the cover with the plastic opening tool.

    添加评论

    • Open up the laptop to unsnap the hinges from the back of the computer.

    • Slide the pin connector and cable through the hinge that connects the display to the rest of the laptop.

    添加评论

    • Remove the transparent tape covering the pin connector.

    • Unplug the pin connector from the display.

    添加评论

    • Cut the tape between the display and the plastic frame using the flat end of a spudger.

    • Work the spudger around the perimeter of the display to separate it from the bezel.

    • The display is attached with a strong adhesive. Applying heat with a hairdryer or heat gun may make the removal process easier.

    添加评论

结论

To reassemble your device, follow these instructions in reverse order.

Nat McCormick

于2018年02月15日注册

645 信誉积分

创作了5篇指南

团队

USF Tampa, Team S16-G1, Boczar Spring 2018 USF Tampa, Team S16-G1, Boczar Spring 2018 的会员

USFT-BOCZAR-S18S16G1

5 名成员

创作了5篇指南

添加评论

浏览统计数据:

过去的24小时: 1

过去的7天: 2

过去的30天: 7

总计 84