简介

The display is the main interaction with the user providing image. This outline will show you how to remove and replace the display from the device.

  1. Remove the ten 7mm Phillips #0 screws from the bottom.
    • Remove the ten 7mm Phillips #0 screws from the bottom.

    添加评论

  2. Insert a plastic opening tool under the bottom cover and slid it around the perimeter until all of the clips release.
    • Insert a plastic opening tool under the bottom cover and slid it around the perimeter until all of the clips release.

    添加评论

    • Remove the two 5mm Phillips #0 screws from the battery.

    添加评论

    • Use a spudger to flip up the retaining flaps on the ribbon cable ZIF sockets.

    • Remove the ribbon cables from the sockets.

    添加评论

    • Disconnect the battery from the motherboard.

    • Remove the battery.

    添加评论

    • The battery is installed in these pictures but should always be removed before any part replacement.

    • Remove the four 5mm Phillips #0 screws from the display hinge.

    添加评论

    • Disconnect the two antenna cables from the Wi-fi card.

    添加评论

    • Disconnect the display cable by pulling it down and towards you.

    添加评论

    • Lift the bottom half of the computer away from the screen while keeping the screen flat on the table surface.

    • This will allow the hinges holding the screen in place to lift up.

    添加评论

    • While the screen is flat on the surface, slide the bottom half of the computer towards the top of the screen to separate the two halves.

    • The screen is now completely removed from the bottom half of the computer.

    添加评论

结论

To reassemble your device, follow these instructions in reverse order.

Joseph

于2018年01月25日注册

565 信誉积分

创作了6篇指南

团队

USF Tampa, Team S20-G1, Passmore Spring 2018 USF Tampa, Team S20-G1, Passmore Spring 2018 的会员

USFT-PASSMORE-S18S20G1

3 名成员

创作了6篇指南

添加评论

浏览统计数据:

过去的24小时: 1

过去的7天: 4

过去的30天: 32

总计 170