简介

If your laptop wont boot, it may be because of a corrupted hard drive. This simple guide will show you how to remove the hard drive for this laptop. Be sure to fallow the steps in order. In the end you will be able to remove and replace the current hard drive.

  1. Remove the twenty-five 6mm Phillips #0 screws from the bottom panel of the laptop.
    • Remove the twenty-five 6mm Phillips #0 screws from the bottom panel of the laptop.

    添加评论

  2. Using the plastic opening tool, lift up on the side opposite of the Ethernet connector.
    • Using the plastic opening tool, lift up on the side opposite of the Ethernet connector.

    • With the plastic opening tool under the bottom panel, work your way around the perimeter until the panel separates.

    添加评论

    • Remove the two 6mm Phillips #0 screws from the battery.

    添加评论

    • Disconnect the battery from the motherboard.

    • Pull the battery up and out of the laptop.

    添加评论

    • Remove the four 3mm Phillips #0 screws from the hard drive.

    添加评论

    • Use a spudger to flip up the retaining flap on the hard drive ribbon cable ZIF socket.

    • Pull the ribbon cable out of the ZIF connector and remove the hard drive from the laptop.

    添加评论

结论

To reassemble your device, follow these instructions in reverse order.

Ed Herrera

于2018年01月25日注册

217 信誉积分

创作了2篇指南

团队

USF Tampa, Team S7-G3, Passmore Spring 2018 USF Tampa, Team S7-G3, Passmore Spring 2018 的会员

USFT-PASSMORE-S18S7G3

4 名成员

创作了5篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 2

过去的30天: 7

总计 60