跳转到主内容

简介

You will need to remove the back cover to access the motherboard. The motherboard is held down by two screws, be careful however, since there are many wires attached to the motherboard from speakers and the microphone.

  1. Open up the phone with a metal spudger, sticking it in the bottom near the cord jack entry.
    • Open up the phone with a metal spudger, sticking it in the bottom near the cord jack entry.

    • Be careful with the amount of force you use, or the plastic may crack.

  2. Pull up on the spudger while simultaneously pulling up the top shell of the phone.
    • Pull up on the spudger while simultaneously pulling up the top shell of the phone.

  3. After unclipping the bottom half of the shell, pull upward from the position shown in the picture to detach the top half of the shell.
    • After unclipping the bottom half of the shell, pull upward from the position shown in the picture to detach the top half of the shell.

    • The cord connecting the speaker is short, and may detach if not done carefully.

  4. You will have the motherboard and speaker exposed to you.
    • You will have the motherboard and speaker exposed to you.

  5. Remove the two 10 mm screws using the 1/4" driver and a J1 Phillips screw head.
    • Remove the two 10 mm screws using the 1/4" driver and a J1 Phillips screw head.

  6. Carefully move the motherboard up to remove it.
    • Carefully move the motherboard up to remove it.

结论

To reassemble your device, follow these instructions in reverse order.

2等其他人完成本指南。

Juan Carrillo

于2016年02月10日注册

406 信誉积分

创作了3篇指南

团队

USF Tampa, Team 4-2, Lacy Spring 2016 USF Tampa, Team 4-2, Lacy Spring 2016 的会员

USFT-LACY-S16S4G2

4 名成员

创作了6篇指南

0条评论

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 1

过去的30天: 8

总计 477